snmp oids for the command "show counters interface intx/y delta"

[ROMAN TOMASEK]

Hello,

I have a question about SNMP OIDs for the command "show counters interface intx/y delta" on Catalyst6500. The customer wants to create graphs for the following values:Overruns, qos0Outlost, InErrors, OutErrors, InDiscards, OutDiscards etc..

Is possible to get these values using SNMP??

Thank you

Roman

[Dan Frey]

These OIDs can be found in the IF-MIB located here:

ftp://ftp-sj.cisco.com/pub/mibs/oid/IF-MIB.oid

Regards,

Dan

[ROMAN TOMASEK]

Thank you, Dan. These OIDs are for the output from the command "show interface int x/y". But I think, that these OIDs are not for the command "show interface int x/y delta".

Roman

[N3t W0rK3r]

I am very interested in this also... especially the qos0Outlost value!

John