07-15-2011 02:14 AM
Hello,
I have set up snmp on one of my routers. One of the lines I have entered is
snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart
The problem is that the router has 4 fastethernet switch ports and I see linkup linkdown messages for all the interfaces however I only want
to see linkup linkdown messages for the dialer2 interface.
Can anyone tell me how to configure it to just send traps for one interface?
Thanks
07-15-2011 04:20 AM
Depending on the IOS version you can say "no link traps" un the interface configuration. (Not sure about exact syntax, and it varies among IOS versions I think )
Cheers,
Michel
07-15-2011 05:41 AM
Hello Michel,
Yes that's what I was looking for. I never thought to look under the interface. The correct syntax is
no snmp trap link-status
Thanks.
07-15-2011 05:43 AM
Yep that's it.
Good luck
Michel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide