Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, my DNAC takes far too long to mark a device as unreachable. If I reboot a switch, DNAC doesn't see it as unreachable and therefore I dont receive an email alert to say it's unreachable. It seems to take a device to be unreachable for about...
Hello, I want to disable ipv6 device tracking (SISF) and have followed the instructions below, but I still see ipv6 addresses in the device tracking database.The instructions below were taken from the document. I have created the policy correctly and...
Hello all, I have set up dot1x on our network and enabled IP tracking. I checked the IP tracking database and it is empty, but as soon as I enable DHCP snooping, the IP tracking database becomes populated. Can anyone explain to me why t...
Hello, We have an ASR1001 and I would like to configure IP INSPECT. According to the IOS XE command reference guide, IP INSPECT is a valid commandhowever when I try to enter the command on the router, it is not recognised. Do I need a license t...
Hello, I have set up snmp on one of my routers. One of the lines I have entered is snmp-server enable traps snmp authentication linkdown linkup coldstart warmstartThe problem is that the router has 4 fastethernet switch ports and I see linkup...
Thanks for the replies. On power up I see the following interfaces1 DSL controller1 Ethernet interface4 FastEthernet interfaces1 ATM interface1 Virtual Private Network (VPN) Module256K bytes of non-volatile configuration memory.125440K bytes of ATA C...
