Hey everyone,
I'm trying to configure SNMPv3 on a switch to send specific traps to a SNMP manager in this case Solarwinds.
I need to collect the following information:
CPU, energywise info, interface status (up, down), temp, trending for related data, IOS version changes, response times, interface traffic and trends, config backup and change management, and STIG check compliance
SYOB(config)#snmp-server enable traps ?
alarms Enable SNMP alarms traps
auth-framework Enable SNMP CISCO-AUTH-FRAMEWORK-MIB traps
bridge Enable SNMP STP Bridge MIB traps
bulkstat Enable Data-Collection-MIB Collection notifications
call-home Enable SNMP CISCO-CALLHOME-MIB traps
cluster Enable Cluster traps
config Enable SNMP config traps
config-copy Enable SNMP config-copy traps
config-ctid Enable SNMP config-ctid traps
copy-config Enable SNMP config-copy traps
cpu Allow cpu related traps
energywise Enable SNMP ENERGYWISE traps
entity Enable SNMP entity traps
envmon Enable SNMP environmental monitor traps
errdisable Enable SNMP errdisable notifications
event-manager Enable SNMP Embedded Event Manager traps
flash Enable SNMP FLASH notifications
license Enable license traps
mac-notification Enable SNMP MAC Notification traps
pki Enable SNMP PKI Traps
port-security Enable SNMP port security traps
power-ethernet Enable SNMP power ethernet traps
rep Enable SNMP Resilient Ethernet Protocol Traps
snmp Enable SNMP traps
storm-control Enable SNMP storm-control trap parameters
stpx Enable SNMP STPX MIB traps
syslog Enable SNMP syslog traps
transceiver Enable SNMP transceiver traps
trustsec-sxp Enable SNMP CISCO-TRUSTSEC-SXP-MIB traps
tty Enable TCP connection traps
vlan-membership Enable SNMP VLAN membership traps
vlancreate Enable SNMP VLAN created traps
vlandelete Enable SNMP VLAN deleted traps
vstack Enable SNMP Smart Install traps
vtp Enable SNMP VTP traps
<cr>
So far I have configured cpu, engergywise, envmon, and entity...what others should I use?
Thanks in advance
