01-20-2020 10:53 AM
Hi All,
I have a router (ASR) with multiple VRFs and SNMPv3 configured.
I would like to send snmp traps to 2 different servers. One of them is reachable through the global routing table and one of them is reachable through a VRF. For this purpose I planned to use Loopback interfaces as source (one in global, one in VRF).
Can I use 2 different snmp trap sources at the same time?
01-20-2020 09:50 PM
- Check the link below for useful hints , if any :
M.
09-15-2021 02:09 AM
Hi,
The solution behind your link sets the source interface (a single one) into a VRF.
But questions is:
Is there a possibility to sent traps to two different trap receivers (in different VRFs)? So in my opinion we need two different trap-source-interfaces (each in the correspondig VRF). Do someone know a solution for that?
br
AM
04-23-2021 02:20 AM
Hello there, did below suggestion solve your isse? I have the same ask. Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: