SWIM Jobs show failed but all images are in flash

[josrankin]

I performed a software distribution on two different 3750 switch stacks using LMS 4.2.3 over a WAN link.

The Job Report shows this:

Copying c3750-ipbaselmk9-tar.122-55.SE4.tar from Software Repository to tftp-specific directory.

Copied successfully to C:/CSCOpx/tftpboot/rep_sw_3381422663941666305

Loading image file to flash device : rep_sw_3381422663941666305 --> flash1:c3750-ipbaselmk9-tar.122-55.SE4.tar using TFTP

Error loading image to Flash. See C:\CSCOpx\files\rme\jobs\swim\5373\3750Stack_telnet.log for the output from the device on which the image transfer failed.

Image Copy Operation Failed

Device is unlocked.

Device Upgrade Result : Failed

However, when I look at the flash on both stacks, the IOS image with the correct filesize, folders, etc. all looks right. The show boot shows it will boot to the correct image. The telnet.log file shows all the files being copied and just ends after the last file (the .bin image).

Does anyone know why this might report as failed even though the files are in flash?

I have not yet reloaded either switch as they are in production.

Thanks.

[josrankin]

OK I reloaded one of the stacks and it came up fine.

Could this error be due to the fact that the upgrade was done over a WAN link and I did not put exec-timeout 0 0 on the line vty?