02-23-2019 05:00 AM
I having a problem in my configuration in cisco switch 3650 since when I run the command
Switchport trunk encapsulation dot1q
it will respond as % Invalid input detected at '^' marker.
What is correct command for this?
Thank you in advance.
Solved! Go to Solution.
02-23-2019 05:18 AM
Hi @blitzkirze ,
Check this answer of the Community:
https://community.cisco.com/t5/switching/cisco-3650-and-802-1q-encapsulation/td-p/2779282
Regards
02-23-2019 05:18 AM
Hi @blitzkirze ,
Check this answer of the Community:
https://community.cisco.com/t5/switching/cisco-3650-and-802-1q-encapsulation/td-p/2779282
Regards
02-23-2019 05:33 AM
02-23-2019 05:41 AM
02-23-2019 06:12 AM
Hi @blitzkirze ,
Check if you can enter the ip routing command. That command enables routing on the switch, so it would only be necessary SVI to configure them as your vlan's gateways.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide