Switch Catalyst 3650

[blitzkirze]

I having a problem in my configuration in cisco switch 3650 since when I run the command

Switchport trunk encapsulation dot1q 

it will respond as % Invalid input detected at '^' marker.

What is correct command for this?

Thank you in advance.

[luis_cordova · Accepted solution]

Hi @blitzkirze ,

Check this answer of the Community:

https://community.cisco.com/t5/switching/cisco-3650-and-802-1q-encapsulation/td-p/2779282

Regards

[blitzkirze]

Thanks for your reply.

[blitzkirze]

Hi,

I have a question again, can I do an inter v-lan in Cisco 3650 ?

Thank you,

[luis_cordova]

Hi @blitzkirze ,

Check if you can enter the ip routing command. That command enables routing on the switch, so it would only be necessary SVI to configure them as your vlan's gateways.

Regards