Switch reset

[pavkad]

I have such a special question, I own a swicht SRW248G4 so this is the first manage swicht from Linksys together with CISCO. Since I used to use it, I wanted to use it now, however I don't remember the IP anymore, putty and hyperterminal won't start. There is no reset button, but I do remember that somehow the LAN ports got connected and a reset to default occurred. Please does anyone remember the procedure of linking those LAN ports?

Thank you

[Mark Elsen]

  - FYI : http://resetrouter.info/router/Linksys/SRW248G4

 M.

[pavkad]

This is a manage switch, not a router device.

https://it-market.com/en/switches/10/100-mbit/s/linksys/srw248g4-eu?number=38164&gclid=CjwKCAjw8cCGBhB6EiwAgOReywpdM1a7SMRspJBOekKPxFOPU8PIuYrdPGeMUduA53KlsKMjpEUO4hoCaWMQAvD_BwE

[balaji.bandi]

check the manual reset :

https://www.linksys.com/us/support-article?articleNum=139032#manual

[pavkad]

This switch does not have a reset button. That's why I posted which one it is.

[balaji.bandi]

as per the model that is the document see, i have not hands on that device, we go with the information, can you post the image of the device ?

[pavkad]

Here, I have a photo of it in operation. The thing is, I can't get past the putty or the hyperterminal. I don't remember the IP I entered to configure it. I read somewhere once that it can be reset by connecting RJ45 to two ports that you connect with a LAN cable and let it go, this is supposed to reset it. But I don't remember where that was. I couldn't find a reset on the motherboard either.

[Mark Elsen]

    - Reset button could be at the back and or post picture of back-side too.

 M.

[pavkad]

There is no reset button on this device either on the back or on the side. Reset should be done via cross RJ45 but I don't know in what order the LAN ports are connected. It's actually the only switch that doesn't have a reset button

[balaji.bandi]

Dont have experience with the Linksys models

did the device has console  ?

https://oitibs.com/reset-linksys-srw-series-switches/