10-27-2014 06:30 AM
Hi Guys,
I need to troubleshoot an package loss issue and for that I would like to use "monitor capture" but it just do not start, see bellow.
ASR1001#sh monitor capture cap_out
Status Information for Capture cap_out
Target Type:
Interface: GigabitEthernet0/0/1, Direction: both
Status : Inactive
Filter Details:
Access-list: acl-out
Buffer Details:
Buffer Type: CIRCULAR
Buffer Size (in MB): 10
Limit Details:
Number of Packets to capture: 0 (no limit)
Packet Capture duration: 60
Packet Size to capture: 0 (no limit)
Maximum number of packets to capture per second: 1000
Packet sampling rate: 0 (no sampling)
ASR1001#monitor capture cap_out start
Unable to activate Capture.
Did anyone face that?
Regards
12-03-2014 02:24 AM
I had this problem too.
When I cleared the "log" extension at the ends of the access-list lines then the problem have been settled.
01-29-2016 08:40 AM
Thanks, worked for me.
11-13-2018 12:43 AM
I had the same issue.
Mine was caused by trying to capture an interface belonging to a port-channel.
Capturing on the port-channel instead of the physical interface resolved this.
11-13-2018 12:44 AM
I had the same issue.
Mine was caused by trying to capture an interface belonging to a port-channel (on a 4500X).
Capturing on the port-channel instead of the physical interface resolved this.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide