11-01-2017 08:02 AM - edited 02-21-2020 06:36 AM
Hi everyone,
I can't type configure terminal command with my asa 5506, does this command has been replaced to the another command? Any one can explain to me this issue ?
Many Thanks
Solved! Go to Solution.
11-01-2017 10:31 PM
There are only a limited set of commands available in the FTD cli. There is no "configure terminal" available.
Configuration (beyond the basic network setup and adding a manager) is done almost completely via the GUI (Firepower Device Manager for local configuration or Firepower Management Center for remote management).
You can drop from the FTD cli into the "LINA" cli to see some ASA type configurations but you cannot configure from there. For that use the "system support diagnostic-cli" command.
11-01-2017 04:10 PM
11-01-2017 04:24 PM
Are you trying to configure an ASA that you have reimaged with an FTD image? or an ASA with the FirePower module?
If you have an ASA with the FirePower module then it is quite possible that it is still connected to the FTD command line and you need to break out of it using Ctrl + Shift + 6.
11-01-2017 08:31 PM
11-01-2017 08:44 PM
11-01-2017 10:31 PM
There are only a limited set of commands available in the FTD cli. There is no "configure terminal" available.
Configuration (beyond the basic network setup and adding a manager) is done almost completely via the GUI (Firepower Device Manager for local configuration or Firepower Management Center for remote management).
You can drop from the FTD cli into the "LINA" cli to see some ASA type configurations but you cannot configure from there. For that use the "system support diagnostic-cli" command.
11-01-2017 11:31 PM
11-01-2017 11:38 PM - edited 11-01-2017 11:42 PM
An ASA running FTD image does not use ASDM at all.
It uses either FDM or FMC (local and remote managers respectively).
FDM (shown below) can configure hostname. Timezone configuration is not allowed after initial setup when using FDM. For that you have to move up to the full featured FMC system for management.
11-02-2017 09:01 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide