ASA 5506X-W WLAN initial configuration

[sebastien.daigle]

Hello,

I'm running a ASA5506W-X (with the WLAN interface).

After looking around, I don't see into the ASDM the Radio or WLAN configuration.

After reading the documentation (http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/5506X/5506x-quick-start.html) at step 6, I'm still unable to get it up and running.

I take a look at the inventory, and I see the module 2, but without details (PID, VID, SN)

Name: "module 2", DESCR: "WLAN AP"
PID: N/A               , VID: N/A     , SN: N/A

Someone also run a ASA5506W-X and can check the inventory of his ASA?

Let me know

Thanks.

[JP Miranda Z · Accepted solution]

Hi sebastien.daigle,

Try following:

hw-module module wlan recover configuration

asa# session wlan console

ap>enable
Password: Cisco
ap#configure terminal

Enter configuration commands, one per line.  End with CNTL/Z.

ap(config)#ip default-gateway 192.168.10.1
ap#copy run start

Then try accessing the wlan GUI.

Hope this info helps!!

Rate if helps you!! 

-JP-

[sebastien.daigle]

Thanks for your help JP!

Now I'm able to access the AP part, and get back to the ASA part.

ap#^Z
ap#
Escape Sequence detected
Console session with module wlan terminated.
ciscoasa#

[james.tran77]

I also need to enable http server

ip http server

[james.tran77]

but now that I am in the GUI, it is horrible. Page errors everywhere. I can apply radio setting and enable it.