09-21-2021 12:56 PM
Reimage to 6.1 version in ASA sfr module in 5508-X.
There is a pre-install package that i have to use in this installation but i dont know what have I to do with that file.
Someone know the command to run this package or when I have to run it?
Regards
Solved! Go to Solution.
09-22-2021 12:14 AM
Hi,
pre installation packages are normally using between upgrades. if you need to do a clean installation, use below guide.
mark this as answer or upvote if this solved your concern
KB
09-22-2021 01:44 AM
@ali.rodriguez Correct - a pre-install package is not needed when reimaging.
09-21-2021 12:59 PM
We use an img file and pkg file. Complete instructions on how the process works can be found here:
09-21-2021 02:06 PM
So, the pre-install package is not needed?
09-22-2021 12:14 AM
Hi,
pre installation packages are normally using between upgrades. if you need to do a clean installation, use below guide.
mark this as answer or upvote if this solved your concern
KB
09-22-2021 01:44 AM
@ali.rodriguez Correct - a pre-install package is not needed when reimaging.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: