ASA upgrade failure

[zain_iq_ali]

Hello team, 

plz your support 

about the below ... the asa without any firmware now .. how can I solve this and the memory i think its filled.

[Philip D'Ath]

Delete old files off the flash you don't need (such as the old firmware).

dir flash:

delete flash:xxx

[zain_iq_ali]

there is no firmware :(

[Philip D'Ath]

Find other files you can delete.  Perhaps old anyconnect packages, etc.

[Karsten Iwen]

Is that the legacy 5505? With the default flash, there is only space for one firmware, asdm and two anyconnect images. If that's the case you have to delete one of the actual used files and then load the new one. You can also delete the running image and load a new one. But you should make sure that no one cuts the power while upgrading ...

[zain_iq_ali]

i entered to rommon and makes may pc as tftp and working with the asa fine . but when i make copy tftp disk ... the ERROR message shown that there is no space .

you can see this