We have a customer that has deployed several FP4110 but are only running ASA's on them. They are requesting a way to centrally manage them. As far as I can tell FMC does not manage the ASA deployed on FP4110. The Cisco Security Manager is EOL. Also t...
Hi guys, I have an Active-Active cluster running 9.6 (5525X). I currently have 3 interfaces: - inside - mpls_link - outside and a network for which I do SNAT from inside to outside. This would be the current scenarion. Now for one host behind...
All,I have an ASA at a DR site that I would like to be able to have it authenticate our telnet sessions via radius. The problem is that the radius server is at 10.10.10.52 and it would be out of the management interface. If I change the radius server...
Hi, The context here is an IOS Internet router with ZBF, ITSP on the outside and CUBE gateway on the inside. SIP signalling and voice media therefore have to pass through the ZBF and obviously we want to create as few holes in the firewall as poss...
Hi, 1) The following config on an ASA5520 doesn't work-unable to provide Internet access for inside hosts. 2) how to upgrade the version to 7.2, see sh flash. Kindly advise. Topology: Comcast/Xfinity>cable modem>0 int Asa5520>1 int> dumb switch. Tha...
In our company we have a ASA5505 connected to a branch office. This setup was done by the branch office's third party IT company. They've used Easy VPN Remote for the setup. Now we temporary could use another tunnel from our office to my home serve...
I'm trying to configure an ASA 5506 (ver. 9.8.1) to allow a device on the inside interface (smartphone connected to local network via wi-fi) to access an NVR (network video recorder) that is also on the same inside interface, however, I would like to...
I have a ASA connect two ISP. I will nat the server's IP with two ISP Address in ASA. I want to achieve,Client which from ISP1 will come back to ISP1,Client which from ISP2 will come back to ISP2? Does this has a solution? -----------ASA CONFIG------...
Hi there. I am a neophyte when it comes to using Cisco Enterprise grade products and I could use some help. I have a current need to setup some outgoing FW rules and I don't know where to go to set them. Specifically I want to "add a rule that all...
Hello everyone. I'd like some information about having subinterfaces on ASA running FTD and managed via FMC. I'm currently attempting to optimize traffic usage, GBICs and flow with ASA connecting to a pair of Nexus switches (VPC running) and get ...
Hello, I have several NATed ports on my ASA to inside hosts. However from the inside if i try to ping my ASAs outside IP address I get no response. How do I allow this IP communication from devices on the inside of the ASA?
I accidentally deleted the default internal certificate on our 5508-X. I've tried recreating using the CLI, but the commands I'm familiar with aren't available. Does anyone know how to recreate one?
IS it possible to setup a site to site VPN with two 5510 ASA's and dynamic ip addressess on both ends?
Hi All! I'm new here, hope my question will be in the right place, anyway here is the thing: You can see my topology below. I have to configure ospf in domain east, end eigrp on west, (I know it is the other way around on the picture, but just i...
I been searching the internet, Cisco and cisco chat and calling resellers to find what is in the Cisco ASA5516-FIPS-KIT parts, software, cables .... anyone know what comes in this Kit?
