Network Security

Two FTDs in an HA pair lost communications to the FMC due to a configuration mishap. A person reconfigured the management by mistake and now the FMC cannot communicate with the FTDs. I have a lab and recreated this situation. The lab FTDs were reconf...

Has anyone has any experience migrating from ASA using firepower services to FTD ? I was not able to find if ACP which are used for the Firepower Module can be applied applied to the FTD firewall once the firewall has been upgraded ?   We are current...

I installed an ASA 5515x with Firepower services version 5.4 about 2 years ago at a customer location.   Also installed is a Firesight Management Center VM version 5.4.   I have read the release notes on ugrading the FMC (version 6.2), and it states ...

Hello Everyone,   Does ASA 5516-X  or 5525-X have the ability to mark/change DSCP?   Reason behind the title of this inquiry is that I'm looking for a sample configuration where we can  mark a data traffic(set it to AF31) from an inside Interface whe...

WE CONNECTED NEW ISP INTERFACE TO OUR CISCO ASA.ALREADY WE HAVE 2 ISP IN ASA.WE CONFIGURE THE INTERFACE FOR NEW ISP AND WRITE NEW NAT POLICY FOR ONE VLAN NETWORK TO CHECK WHETHER INTERNET IS WORKING OR NOT,INTERNET IS NOT WORKING.   OUR NAT POLICY IS...

  Hi all,   I was involved in software currency and have to make sure all the Cisco devices (Routers/Switches) which are running IOS or IOS-XE software should be upgraded to latest software versions.   Is there any way I can verify if a software vers...

i have infoblox dns and cisco firepower as edge FW but i have issue , when i see intrusion event in cisco firepower i found that the IP of infoblox dns is the top ip in event , i want to view the original Client IP before it goes to infoblox dns serv...

I need to know if i have FP2110 with IPS license and i need to make HA between them do i need extra license to do HA or not ?

Would anyone be able to advise on how to enforce SSH v2 for connections passing through an ASA firewall?  I'm aware of the 'ssh version 2' command, however my understanding is that this relates only to SSH connections to the ASA for management. I've ...

Hey guys,   I recentlly purchased 2 ASA 5506-X to replace Meraki MX50 appliances and I'm running into an issue. Basically UDP traffic including port 67 is being discarded inter VLAN   My configuration: ASA-tunk port-SWITCH-trunk port-WLC             ...

HelloI try to test redundancy management interface of module 1 IPS  8Management 0/1 (core SSP in slot 0)Management 1/1 (add-on module in slot 1)(GigabitEthernet RJ45)9Management 0/0 (SSP in slot 0)Management 1/0 (add-on module in slot 1)(GigabitEther...

I am trying to figure out the IP addresses required for Firepower 4100 series bundle and FMC mgmt setup.  Here is what I have figured out so far: - One IP address for each Firepower chassis (managed through either firepower chassis manager FCM GUI or...