Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Resolved! ASDM Demo mode

Hi Guys, Just want to ask if Demo mode in asdm is still working?. I tried to look the file to download and install but I can't see it on the downloads section. Is there anything I need to know? Where is the location of the the .msi file and what is t...

Hello all,    I have a single ASA 5512-x Firepower Edition running firewall IOS 9.6(3)1.   We have dual ISPs. ISP1 and ISP2. These links are not setup in an active\standby failover config.  ISP1 is the default route out. Everything uses this as its i...

Resolved! Firepower License

Hi, A customer has bought a ASA 5515-X with Firepower Services 6.0.0. I have added the license for the device (VMware with 2 Devices) but he hasnt licenses for the services (URL, etc)   When i enable the service policy into the ASA and send the traff...

I have installed FMC and registered 2 SFR module successful.  I have also configured ASA to send traffic to SFR for traffic analysis but still I am not able to see any traffic on FMC being analyzed. Below is the ASA config :   ASA/act# show service-p...

 Dear expert,I have a pair ASA 5525x version 8.6(1)2 running in active / standby mode.I was asked to enable the IPS Module.  The scenario is as follows:If you have only one inside network, then you cannot also have a separate management network. In t...

hktotti228 by • Community Member
  • 2802 Views
  • 2 replies
  • 0 Helpful votes

I'm trying to setup a 5506-x but unable to reach the internet. When I do a 'show ip', the outside network has 'unassigned' for an ip address. I was hoping someone could go through my config to tell me where I am going wrong. If I can get one interfac...

Dear Team,Recently we have configured Site-Site VPN on box ASA 5525 to access remote machines via RDP. Is it possible to know how much RAM/CPU would be utilizing for the VPN connection as I have to record for reference? Also wanted to understand how ...

wajid_dabir by • Frequent Visitor
  • 772 Views
  • 1 replies
  • 0 Helpful votes