Hi, There is any way to implement this type of exclusion ( feed list from Microsoft ) to create a rule for exclusion all Office365 IPs and URL ( https://go.microsoft.com/fwlink/?LinkId=533185 ) from SSL encryption. My goal is not decrypt any co...
Forum Posts
Guys I have to upgrade a couple of our ASA 5550 firewalls from 8.4(7) to 9.1(7). I am not able to get information related to configuration changes between them. Can anyone please help me with this. Thanks Ravindra
Resolved! Upgrading to FDM ASA 5506-x
I have a quick question regarding migrating from the base asa 5506-x k9 to the FirePower Threat Defense to use the FirePower Device Manager. Is an additional license needed to use the base FirePower? I know Smart licensing is need but can the base li...
As the title says, does the asa 5525-x support zero touch provisioning or any other kind of automated installation? I can't seem to find anything online anywhere. many thanks.
Hello everyone, I recently had the opportunity to use Firepower 4110 appliances for Backup and Restoration tests. Now, I need someone to back me up on my findings or correct me where I went wrong. As far as I am concerned, you can create two Back...
Resolved! Firesight Virtual Appliance License
Hey Everyone I have a lot of Cisco ASA's under my management, and a lot of them has FirePOWER running. Today I only have a FireSIGHT console will 2 devices (5555X, 5512X). I want to add several 5516X and 5506X to the console. I got a price for l...
Hi there, I am new to Cisco but recently got a Cisco RV340 Dual WAN Gigabit VPN Router for the purpose of using its S2S functionality to establish a connection to Azure Cloud. The Router is behind another edge NAT with port forwarding to udp ports...
Resolved! Readiness check stuck
Hi all, I am doing the third upgrade to 6.2.2 version (two upgrades were done without errors) and when I run the readiness check my browser crashed. After reopening the browser the process was stuck. I did not check it and I tried to start it again....
Hi There, i have cisco 5516-x with FP module and FPMC installed on VM (6.0.1). i have added license and enabled them for device. also i have added service policy rules in ASA 5516 with enabling firepower inspection. but still i am not able to do URL ...
I have setup a CallHome feature on a UCS through the GUI. I've followed it step by step in accordance to the instruction that I pulled from Cisco.com. However, I am not receiving the alerts or even when I click on the send inventory button. If I go i...
I have a new set of Firepower 2130 appliances and a Management Center 1000. One of the differences between the 5525x and the Firepower is that some users can run traceroute, tracert or mtr and get useful information. Other users cannot get past their...
Hello Experts, I need your help with a configuration bit for Object based NAT - Natting two public IP to one private IP. I am asked to nat two public IP to one private IP 8.xxx.xx.90 and 8.xxx.xx.92 to nat to 10.53.19.8. 8.xxx.xx.92 nats to 10.5...
Hello, This could be due to pure ignorance on my part, but I noticed odd behavior on one of the ASA's I manage. There were a couple clients showing as the source IP for a SYN Attack. Of course, I jumped to malware and scanned the heck out of one ...
It is to my understanding that there are only specification differences between the two models listed in the title. If I wanted to restore a backup from a 4140 to a 4120 appliance, then will I run into any problems? Is this possible in the first pl...
Can I do a direct software upgrade from 9.1(4) to 9.1(7)23?
