Network Security

Created a STATIC NAT and Filter rule for a remote connection to our new phone system but can't seem to get it to work. any suggestions.

I am trying to allow access to a DNS server on a custom port. object HOST_192.168.2.51_32 description DNS Server host 192.168.2.51 nat (inside,outside) static interface service udp 53 5353 access-list outside_access_in extended permit udp any HOS...

Hi here is the problem. Router1  SITE1--------- INTERNET ---------SITE2   ASA------Router2. wanted to setup a VPN site to site vpn between the ROUTER1 and ROUTER2. however as there is a ASA between. is it possible. do not want to configure a VPN on...

Hi friends, I'm trying to set up an access for a PC from internet to my ASA 5580 for testing purposes. I'm trying to do it through ASDM following the ASDM Assistant but I can't. At the very begining when I try to add a new Connection Profile every op...

Hi,We have a site to site IPsec vpn as well as a LES circuit to the same destination. Some traffic will use the VPN and other the LES connection.I need to temporarily kill the site to site VPN to do some testing and am looking at suggestions for the ...

hi, i just applied 1-year and 3-year TAMC (URL filtering, AMP) licenses to FMC and would like to change the 90-day eval license currently applied on ASA 5525 FP modules. a few questions: 1) could someone advise on how to do it? do i untick then tick ...

Hi, I am just configuring some very simple post 8.3 NAT statements. network object mapped-ip host 1.1.1.1 network object real-ip host 2.2.2.2 My next line of configuration would normally be something like the following nat statement included in the...

Hi, FPR2130 with 6.2.1. 1st question - how to properly check port-channel status? From CLI there is command #show port-channel, but it is not working (and withing LINA this is not implemented). Basically, there is no way to reasonably check LACP sta...

Hello ASA community,Has anyone tested this scenario, and what are the license requirements for this to work?Following link suggests it is doable from technical standpoint:https://search-prd.cisco.com/topic/news/cisco/cs/cs-asa/dsc25457.html"You can s...

Hello all, I'm having some trouble with configuring an Cisco 881 router with CCP. I'm still learning my way through the way Cisco handles firewall. I'm trying to block all but a few ports going to a particular network device in the network, and I ca...

Hi There!! In a Company where I offer technical Support , there are several Fw´s like 5580,5525, 5555, But I would like to Know if There is device /Software thata can operate like a Centraliced device for those ASA´s ? The only option I found is the...