Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have a problem when i do Call transfer my Ip Phone still busy
I have received a call from outside by GSM to my IP Phone 101, i did transfer to another IP Phone 102 , The IP Phone 103 call 101 but it's found busy (101 still busy). where is ...
Hi All,
I use CME for telephony. When i make a call to a number phone, the automatic response asks me to dial a code to etablish this call. but when i dial the code i have no effect the automtic response asks me again to dial the code.
what should i ...
Hi all,
I have a problem with a transfer call between SIP Phone and SCCP Phone. the signaling it's ok but i can't hear a voice when i unhook. i think the probelem is with RTP Protocol because the signaling protocol it's ok. what you think about this...
thanks Abhay,
quitvoice-card 0 dsp services dspfarm!!!voice service pots supplementary-service qsig call-forward!voice service voip qsig decode allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connect...
Thanks Manish for your reply, the IP Phone is enregistred and work well just this issue,
CME version is 15.4
my config as following:
voice register global mode cme source-address 100.30.60.1 port 5060 timeouts interdigit 2 max-dn 600 max-pool 260 t...
the is no output from debug
Router#debug voice vtsp inoutvoip vtsp inout debugging is on
Router#
thanks i have the same problems i didn'tfound a solution for that
