Network Security

Does anyone know how in the world I should login to the ASAv when deployed in AWS? I deployed it, it has an elastic public IP attached to it, when I ssh to the ASA I get a login prompt but I can't login to the device no matter what I try. I've tried ...

I have a sub-interface assigned with an IP, name and security zone interface Ethernet0/1.5 vlan 5 nameif FirewallTransit security-level 50 ip address 10.5.1.2 255.255.255.252 when I issue a show int ip br, it is unassigned, I have tried to rebuild ...

Hello Cisco Community,Please, Can anyone clarify the Cisco AMP Integrations available today ? As I can see there are four possible solutions : AMP for NetworksAMP for EndpointsAMP Private Cloud Virtual ApplianceAMP Threat GRIDWhich are the possible i...

Guys, have anyone deployed 4100 into a cluster layer 2 ? How is this different than ASA 5585 X ?  Please share your experience ..

Hi Friends, I wanted to upgrade the ASA 5520 firewall version 8.2 to 8.4 ? is there any risk to upgrade ?  does automatically old configuration is changed to newer configuration  or shall i configure manually all the configuration after 8.4 upgradat...

Hi All I'm trying to install an ASAv (9.7.1) on to an ESXI 5.5 server using vsphere client. I've followed the instructions and was able to deploy the ovf file without issue. When I got to boot it however, it gets stuck in a reload loop just after it ...

Hello I have purchased cisco FS-VMW-10-SW-K9 license and activated from Cisco License Registration Portal. It must active FMC. But when I added license to my FMC, and the follow message appears: "FireSIGHT licenses are no longer required for Firepo...

Need your help in resolving this CPU issue due to AuthManager. I'm seeing the issue on the Cisco 3750. Thanks. vrian

Hello Everyone i  was configuring OSPF and i configured the auto-cost reference-bandwidth on all other routers but  the command is not supported in cisco ASA 5585 and ASA 5555 so what is the equivalent command or can i just leave as it is does it hav...

The Cisco Firepower Malware Storage Pack, SSD (FPR-MSP-SSD) is mandatory for AMP Service?

is it possible to add local rules via cli instead of the web interface? We want to add rules based on internal research. In snort we could ssh in and add local rules. Can you still do that with FirePOWER? thank you SKP

Dear Friends, Can we configure captive portal in CISCO  ASA . The requirement is. Employees should use their login username and password for accessing the internet. The username will be either a local user or LDAP user. Plz help me

Hello , We had a migration from an existing FWSM to ASA cluster.Configurations are exactly replicated with the new commands. Issue description:- We have two interfaces-Outside and DMZ. Application server is in DMZ and a DB server is in outside.Applic...

Hi, I have a pair of ASA 5520 firewalls and have basically same hardware but when I do sh ver on each of them, I see one have  Internal ATA Compact Flash, 512MB and another one have  Internal ATA Compact Flash, 256MB I am not sure if this compac...