Hello all. Is there any way I can configure my ASA to keep internal all NTP traffic from a certain subnet? There are embedded devices and appliances on this network where NTP configurations are not available and the NTP servers are randomly chosen vi...
Good Day All, The Firepower appliance is currently capable of detecting against vulnerability assessment by default, am I right on this? I think I recalled on the previous versions that there is an option to enable NMAP scanning in the intrusion pol...
Hello,I spent some time to locate the documentation for backup/restore in Firepower 9300 managed FTD modules.I have found the one that talks about FTD modules in Firepower appliance 7000 & 8000: https://www.cisco.com/c/en/us/td/docs/security/firepowe...
Hello -We have a 5525-X with 1 gig connection, we introduced a fairly large number of users to our environment in the last few weeks and notice in the afternoons a slowdown until a reboot of the firewall. We are on 9.6.1. Our show conn count:54914 ...
I got a new 5508-x at work. Out of the box went through the defaults via wizard, changing the internal and management ip (already in use somewhere else). Rebooted as instructed, everything looked good. The prompt I get is a > symbol but I'm not in...
After installing Cisco FMC and enabling Evaluation Mode i am getting the following screen: But before it was working very fine..i had Base and Malware..?..can anyone please help.?
FMC is sending eStreamer logs to Qradar, when we look at the logs, source is being seen as FMC, how to identify the original FTD device that is sending the logs? Looking at the eStreamer payload, I see the field flowStatistics.deviceId=3 but I am no...
Hi, we have a 10mb up/down line and the policing i have tried to configure isn't working. Basically i want to stop any one user from using all of the 10mb OR if theres another way please let me know. I would like to prioritise the VPN connection Can ...
Hi, I have an ASA5506 with basic config, my router is set to bridge mode and i have configured a PPOE for the outside interface,but still cannot access to internetcan any one help ? this is the configuration of the Firewall : Saved::: Hardware: ASA...
I have a problema with the web access to my ASA5506x ssl_error_no_cypher_overlap I dont have web access
Hi All,My customer has asked for advice regarding their FTD and VPN modules. In short, they need to replace their VPN. They have been previously advised that they still needed to run ASA code; so, given the 6.2.2 FTD release, thy are asking if the...
Hello -We have company that has 2 sites, each are network independent of each other. One in India and the other in the states. There is a circuit between the 2 companies that already carries some traffic (http) and it is working. We are trying to set...
Hi, Running into a problem with Firepower Mgmt Center 6.2.0 and is throwing out a question while i wait for TAC reply. I am trying to setup Firepower Mgmt Center 6.2.0 on an VMware ESXi 6.0 host, everything seems fine until i get the error sda: WRITE...
Hi,I am trying to install a windows 10 preview but wonder if ASDM works on windows 10? If so, which version of ASDM you use? Thanks,/S
Hi, I plan to have a router/firewall with just port 443 allowed on edge network, and port forwarding setup to internal server ( a netscaler providing VPN ) in DMZ. I'm trying to understand if having an IPS configured would be beneficial or not. I un...
