Network Security

Hello Folks! I installed a Firepower Management Center (VM) and include 03 ASAs from different locations all in the same domain. When I see the statistic such as traffic I can´t figure out from what link or ASA are all informations. How can I see th...

Hi all, I created a service policy rules and enabled the ASA FirePOWER inspection,but i can't see any traffic in the firepower module.How do i duplicate the traffic from asa5506-x to the firepower module?Plus, how do i monitor the traffic in firepow...

Can someone shred some light on the Cisco ASA best practices that can be adopted for anyconnect vpn and security functions.

Hi,  I have ASA5520 with AIP-SSM-20 module using to protect my department. My outside interface is connected to my company IT network. I need auto update for IPS signature. My IT department provide me a Ip on which internet access is open is 172.16....

Hello Everyone, I did the setup for firesight 5.4.0 and sourcefire also run 5.4 version. Everything works perfectly and even i created some rule to block URL's and getting the desired result that is block page. But when i check the Dashboard or under...

hi ,I was trying to update my firesight from 5.3.1.7 to 5.4 ,I have faced with this problem .Which commands can i execute for thsooting ?

Hello folks! This is probably obvious to some of you, but it wasn't to me. On an ASA 5520 running 8.2(4), I intended to have two different lower-security interface IP address/port sets translated to the same internal IP address/port. The logic behind...

Hello,  I have a RV042 and on LAN a RW110. I receive too many security_notifications with numerous line like this one : May 10 12:26:59 2016 MYROUTER-NAME kernel: #warn<4> ACCESS_RULE: IN=eth1 OUT=eth0 SRC=192.168.0.40 DST=192.168.1.200 LEN=64 TOS=0x...

Hi Guys,I have a question for you.I don't understand the difference between 500-285 and 500-290 exams. Both are about NGIPS and very similar.Any ideas?Thank you in advanceLorenzo

I have been tasked with some ASA configuration coming in a few weeks, and to test out some configuration options I have setup a web server on my local network which I would like to be able to access from via WAN with one of our static IP that ISP has...

Hello, I tried to search for the meaning of this message but cannot find it, can anyone help? %ASA-4-722037: Group <> User <> SVC closing connection: Transport closing. I found the explaination of message error as: 722037 Error Message %ASA-5-722...

I logged into the FireSIGHT and clicked on Policies tab -> Access Control tab , it shows "Access Control policy out-of-date on 2 devices. Intrusion Policies out-of-date on 2 devices". Clicked on it, it takes me to the pop up screen like this (in ...