Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi, Team we had an issue with the ASA failover  the one should show standby , but it show failed State Last Failure Reason Date/TimeThis host - Secondary Active NoneOther host - Primary Failed Ifc Failure  inside: Failed could you help to undertand ...

Hello everybody, As far as I know there is no Deep Inspection engine for MSSQL in Cisco ASA, so here arise a question. How to inspect MSSQL traffic in Cisco ASA or better to say how to inspect a custom service or port , where there is no Deep Inspec...

  We have received following penetration vulnerability for Cisco ASA Firewall 5500 (S/N: JM164940Q0) Vulnerabilities Risk/Severity Recommendation by vendor for closure of vulnerabilities Multiple issues related to SSL certificates were identified...

Hi, I have the following  configuration , but it does not working , logging enableno snmp-server locationno snmp-server contact snmp-server host INSIDE 192.168.2.1 trap community passwordd snmp-server enable traps syslog logging history notifications...

susim by Level 3
  • 2586 Views
  • 2 replies
  • 0 Helpful votes

NAT

Hi All I have a server on our internal network that has very limited access from the internet. Therefore it has an external address that is NAT'd at our firewall. However I want to arrange to access the server from our LAN also using its external add...

Jim Kerr by Level 1
  • 374 Views
  • 3 replies
  • 0 Helpful votes

Hi, Need to know the explanation of  NAT access-list policy extended permit ip host 192.168.60.207 host 192.203.187.140 nat (Outside) 1 access-list policy Above is zero nat zero that says if source is 192.168.60.207 and going to destination 192.203...

mahesh18 by Level 6
  • 485 Views
  • 5 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card