Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi, I was trying to add ASA to prtg for snmp monitoring . Could not create the sensor SNMP Traffic on device Device (). Sensor does not get response from device. SNMP credentials are wrong or device does not support the required uptime OID (1.3.6.1.2...

kp-tkr2014 by Level 3
  • 10591 Views
  • 6 replies
  • 0 Helpful votes

Hi, I'm having a problem with asa, when the scanning threat detection is enable after some time ping time of hosts to outside becomes unstable and so high. I checked that when i disable the feature it becomes stable for some time. I have enabled shun...

kh.farhad by Level 1
  • 1313 Views
  • 3 replies
  • 0 Helpful votes

I'm doing PoV of Cisco ASA with FirePower with my customer. I would like to integrate firepower to MS Active Directory. Everything seem work properly.   - Installation of Firepower user agent complete successfully. Connection to AD work fine. All Log...

suradech.por by Frequent Visitor
  • 3912 Views
  • 2 replies
  • 0 Helpful votes

Hey Everyone; I'm kinda new to this firewall; but here's the issue i have 1. Unable to ping other ASA ip from different Vlans; Ex: if im on vlan 10, i can ping all my other ip address; its just i can't ping asa vlan 15; its stated "Routing Failed to ...

j_j624001 by Level 3
  • 1793 Views
  • 13 replies
  • 0 Helpful votes

Hi, Asa active /standby  Asa 1  192.168.1.10  Inside  asa 2  192.168.1. 11  Inside  Traffic capture shows  122 scps  between inside interface  scps must be between failover interface ?  Thanks

elite2010 by Level 6
  • 693 Views
  • 1 replies
  • 0 Helpful votes

Hello folks, I just deployed an inline firepower sensor and added it to the FMC 6.0.  I have created a simple access policy with Intrusion Prevention. It's been in service for the past 3 hours and I don't see anything in the management console. The p...

Martin Houde by Frequent Visitor
  • 2047 Views
  • 2 replies
  • 0 Helpful votes

Hi all!Recently I'm upgraded my workstation from ubuntu 14.04 to 16.04 and ASDM (7.6.1) can't run now with following error: net.sourceforge.jnlp.LaunchException: Fatal: Launch Error: Could not launch JNLP file. The application has not been initialize...

I've got a simple NAT router. Fa0/0 is outside and Fa0/1 is inside. Inside network is 172.16.1.0/24. Outside network is a single dynamic public IP assigned from the ISP. I'm trying to implement a "Deny by Default" rule set that denies all inbound tra...

mattlager by Community Member
  • 8964 Views
  • 10 replies
  • 0 Helpful votes