Network Security

Looking for example of working mpls-tp configs for ASR 903. 1) using "unnumbered" interface 2) numbered ip interface 3) epipe 4) vpls =============================================================== Following the Cisco ASR 903 documentation I am unabl...

We have bought ASA 5585-X with one SSP 40 on slot one "ASA5585-S40-K9" and now we want to add FirePOWER capability to this device. As I checked it seems there's FirePOWER SSP 40 card which we can buy and install on the slot1 and now I just need the c...

Dear All, We've bought "ASA5585-S40-K9" and "ASA-SSP-40-K8=" which we end up with one ASA 5585-X chassis and with two SSP-40 card installed in both slots and now customer security team request has been changed and they are asking for IPS functionalit...

Hello, i am trying to copy the Anyconnect packages to our ASA and getting the below error. %Error copying disk0:/anyconnect-macosx-i386-4.2.01022-k9.pkg (No space left on device) show disk0: output shows that there's 98 mb free on the device. show...

I have ASA 5512 with version 9.4(ASDM version 7.4). ASA is connected to load balancer (Ascenlink). I read than we can disable nat control after version 8.3.i looked inside configuration and ASDM, i didn't found no nat control.how can i do that. I wan...

Hello ALL, I want to migrate this PIX configuration to my new ASA configuration.  Any help to translate this ?  crypto ipsec transform-set myset esp-aes-256 esp-md5-hmaccrypto ipsec transform-set strong-des esp-3des esp-sha-hmaccrypto dynamic-map ci...

Hello Cisco Security Team, My Name is Moustapha I am Network Admin in Small Company and i am using Cisco ASA 5515-x i want to add a new I/O  Slot ASA-IC-6GE-SFP-A MODULE or 6 extra interfaces and when i fix the module properly and i restart the ASA ...

Good morning, I have 2 5516-x's in place at one of our remote locations, site C.  This site is a failover site.  Well, not at the moment because the site to site tunnels do not allow internal network access.  Both site A and site B connect to site C...

Good Day All! I have customer very keen to fix the whole issue with version 6.0.0 release in their environment as of currently they just migrated their network and security devices to Cisco. However we ran into some issues with their AD on version 5....