hiVersion 9.1I configured my "admin" context to transparent and the "Firewall" context to routed.It was my fault. "admin" context should be routed and "Firewall" transparent. via Command line changing "fiewall" context to transparent was working bu...
Hello everyone: After a scanning performed on some networking devices a couple of weeks ago--many of these belonging to Small Business family-- some issues came up. " 65821 - SSL RC4 Ciphe Suites Supported" ...
Hello,I am looking to know how or where I could find out the list of bugs or issues of a particular OS version. When I see the release notes I don't see the list of bugs in that release rather it talks about the fixes of other versions/releases. Can ...
Hi All,I want to create a NAT on my ASA to allow inside clients only to NAT out the Outside Interface to a certain port, e.g 7575.I would use after auto on this also due to some other static NATS.Is there a way to limit the actual NAT statement to us...
Dear Friendz, Currently we are using ASA 5525 in Active-Standby pair (Firmware - asa922-4-smp-k8.bin) and planning to upgrade the same, aware about the firmware up gradation process but would like to know about rollback (revert or downgrade steps) . ...
Hi...I am new to cisco firewall.. my office decided to buy a cisco asa 5515.I'm configuring it via asdm software. I have followed many tutorials on the internet,but I still can't access my server behind the asa.I attached the show run config from the...
Hi All, I have configured an ASA in transparent mode however I am experiencing some issues as follow: I have an inside and outside interface on the asa which is passing traffic from the same subnet of 192.168.0.0/24.Host is 192.168.0.11 and gw is 192...
We have a custom device that can not be re-coded. It's IP is 10.10.161.146. It's host name is TOM. TOM wants to grab the NTP data from his default Gateway, which is the ASA inside interface (10.10.161.1). The ASA get's it's NTP from a router called...
We have VOIP phones and two of them have side cars with the extensions on them. The device allows us to see who is on the line and also to select an extension to call. We've found that the ASA is blocking the UDP sessions from the device after a cert...
Good afternoon all, I need to ping a very large amount of IPs and return the results in a readable format. What's the easiest way to do this? To give some scope... There's about 340 entries in the arp table, to which there's 400 or so statics set (no...
I have a remote site at a customer I am working with and they have a 5505 at the head-end. We have put in a L3 switch behind the ASA with 4 networks on it and the switch is handing out DHCP and all of that is working fine. The networks can ping each ...
We're looking at exposing a service to the public interface, but want to lock it down to only specified MAC addresses and/or IPs being allowed to access it. From what I understand from this thread - https://supportforums.cisco.com/discussion/1175409...
