Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi There,I am creating a new ACL on an ASA.I used the following commandsaccess-list VLAN127_IN line 20 remark ***Deny Traffic to Rest of Lan***access-list VLAN127_IN line 30 extended deny ip 192.168.127.0 255.255.255.0 10.0.0.0 255.0.0.0 (hitcnt=0) 0...

GRANT3779 by Spotlight
  • 912 Views
  • 1 replies
  • 0 Helpful votes

I set up my switch, the port security is activated, but when i have 2 ports configured in same vlan, when changing the computers conected in those ports between them, the ports are not going in shutdown, only discard packets. How can i configure to s...

dani289200 by Level 1
  • 27730 Views
  • 6 replies
  • 0 Helpful votes

Resolved! ASA5505 NTP Config

Hello,  We have stand-alone hosts(not on a PDC) behind an ASA 5505 and we would like to configure their clocks to synch up with an external NTP sources. I wasn't sure if I could configure the ASA to use an external NTP sources and then point the host...

zekebashi by Level 4
  • 651 Views
  • 2 replies
  • 0 Helpful votes

Hi guys, I'm having a strange behaviour in an ASA cluster running 8.4(4) regarding failover feature, from the Active node standpoint if I issue a "show failover" I have the following result------------------ show failover ------------------Failover O...

I have a need on Cisco 2800 router IOS 12.4 (15) to map  an Remote desktop session to a different port number on a server.A public ip address say 1.1.1.1 is static natted to an inside server at 2.2.2.2A user on the outside will try to make a connecti...

pcromwell by Level 3
  • 543 Views
  • 2 replies
  • 0 Helpful votes

Resolved! about ASA firewall

  Hello everyone, I have a question about ASA firewall, is it true that in ASA firewall, their are 2 ways we can configure it? Either we use GUI mode to access the ASA firewall or CLI mode? Is the GUI application basically the ASDM that we download a...

I am trying to setup NTP from a router that is behind an ASA. I am trying to sync it with time.nist.gov (UDP port 123). However, the "sh asso det" list the NIST server as "insane and invalid". The ASA does do a source NAT and also changes the source ...

agoraya by Level 1
  • 716 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card