Network Security

Hi All,I am having issues with the ASA 5510 management interface.I can't communicate with this interface. It is showing DOWN/DWON evenif I type NO SHUT several times.My existing config is as followsour-asa-01# sh run: Saved:ASA Version 7.2(5)!hostnam...

I am fairly a newbie to the ASA 5505, and I'm currently only familiar with ASDM to configure this thing until I get some classes under my belt.My question is this... We have a 5505 and I have configured a separate inside and guest network. Vlan 4 is ...

hi all,It was first time I tried to turn on priority qos on 8.4 soft and modified the buffer size but when wanted to check strange values were displayed. ASA(config)# show priority-queue configPriority-Queue Config interface outside current         d...

I have a cisco ASA configured for AnyConnect clients.  I also want to pass 443 traffic back to an internal web server, but not sure if I can do this since the AnyConnect clients are already connecting over 443 to the ASA, right?

I am a little uncertain if I am required to do anything else.  Or perhaps I am misunderstanding and the Identity cert doesn't need the same trustpoint as the CA cert?I get a FAIL message when I run the crypto ca authenticate command for my certificat...

Hi ,I have ASA5585 in routed mode (Check the attached diagram) , and my DHCP client on the inside , while the DHCP server is on the outside.I know that ASA can be configured as a DHCP relay , but there is a condition “DHCP clients must be directly co...

i has ASA 5520 that has no any OS images in it's flash disks, and i want to boot it first from the tftp then copy this image to flash disks ( if the tftp boot suc ) and i did the below config :---------------------------------------------------------...

Dear all,we have cisco ips Version 7.0(2)E4 recently its analysis engine stopped working , folowwing is the logs for the IPS devices and also please check the attached screen shot for detail.# show healthOverall Health Status                         ...

Hola a toda la comunidad.Quisiera consultarles algo, he adquirido un Cisco ASA 5505, deseo configurarle Inside, Outside y Dmz, así esta mi escenario:Internet----ISP--outside-(1.1.1.1 En realidad es mi ip publica)--CiscoASA5505--inside-(192.168.5.1)--...

Hi All,I have my AIP-SSM set up working with my 5520 ASA, and the device is passing packets, but how do I actually confirm it is doing what it is supposed to? I can see that it is processing packets, but I can see no way of verifying what it is doing...

I'm not clear about the capabilities of the ASA 5510 GigE interfaces (eth0/0 and eth0/1) with an without IPSEC tunnels enabled.This page http://www.cisco.com/en/US/products/ps6120/prod_models_comparison.html shows a figure of 170Mbps 'Maximum 3DES/AE...