hi everyone, am trying to configure TID in cisco fmc but i faced issue with some sources "they stuck in parsing mode" so i apply this solution in fmc https://community.cisco.com/t5/cisco-bug-discussions/cscvd29174-allow-user-to-delete-tid-sources-whe...
Hello!I have an FTD 1010, running FMC 7.0.4-55. We are trying to access a website, https://tx.c2tinc.com/register, and it consistently times out when accessed from behind the FTD. When I filter the traffic to view the connection from my IP as the sou...
We currently have Cisco 9300 switches and the devices connect via 802.1X authentication. How can I configure Cisco switches where users can connect their laptops and it will put them in the correct VLAN automatically with 802.1X authentication. I d...
Hi All, I have one password enableThe command is:(config)# enable password... There is any option to configure second enable password on the switch?Thanks for help
We currently have Anyconnect with the ISE Posture Module installed. We are using this to posture devices on our wired network before granting network access. Our computers already have the software installed but not the ISEPostureCFG.XML which has th...
Has anyone set up auto back up on ASA firewall to SMB? I can't find useful directions on doing so. Any help will be appreciated. Thank you
Hi all,I would like to ask cli commands to restore FMCv backup via cli. Could you pls share to me?Highly appreciate your help. Thanks,Su Myat Lwin
Is it impossible to backup from the cli when the ISE application server status is initailizing? ise version : 2.7 patch 4
In the Devices/Troubleshoot/Packet Tracer section in the Firewall Management Center (v. 7.2.4 - build 169) my Cisco 2130 no longer shows as an option. It does show everywhere else it's supposed to (Packet Capture, Device Management, etc). I tried res...
I don't see or can't find doc info on how to do this. Any help? Seehttps://www.cisco.com/c/en/us/td/docs/security/secure-firewall/management-center/admin/730/management-center-admin-73/events-intrusion.html
ASA with FirePower had a "fail open/close" setting to control access in case of SFR module failure. From what I can tell, with an FTD device the IPS function is integrated into the firewall (LINA?) so is this setting NA in the FTD environment? Thank...
Hello, Our FMC appliance is using with the Smart Licensing. Our Perimeter FTD appliances are registered to this FMC (we have URL, Threat and Malware subscriptions). The licenses will expire in the next couple of days and still we are in the process o...
On a Firepower 4140, if you already have a single native instance of an FTD running on the chassis, is it possible to add container instances after that? or would you have to delete the native instance and start over?Thank you.
Hello community, i'm just a new CCNA R&S certifiedWhen configuring port-security on an interface of a Cisco c2960 Series, i face a small issue because i wanted to insert 250 secure static mac addresses on port fa0/15 without rewrite the same command ...
Dear community,we are facing the issue explained below. packets are not being encapsulated, encrypted to the IPSec tunnel on following SA10.118.32.0 255.255.240.0 10.100.0.0 255.255.255.0ipsec sa clearing does not fix the problem.asa version is ASA 9...
