Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I am trying to configure a site to site ipsec vpn with 2 cisco 5505 ASA's. Unfortunately when i open up the ASDM there is no vpn wizard to start the configuration.The version of ASDM i am using from flash is 645-206.bin and the firmware on the ASA's ...

Hi,Hope you can help.As you know the ASA code 8.3 and higher uses NAT objects and totally changes the NAT rule config.I am new to FWSM .... but was wondering if this comparable  ?I am lookinig at upgrading FWSM 3.1(16) to a higher 4.1 version .... bu...

mcroft by Level 3
  • 1032 Views
  • 2 replies
  • 0 Helpful votes

I have a cisco asa 5520. i need to forward telnet to a router on the inside interface. Here is what i have done so far but it doesnt seem to be working.I have created an access-list that looks like this:access-list 102 extended permit tcp any host 10...

i am currently looking at the suitability of replacing an 'airbreak' firewall with 2 new ASA 5505'S.One stipulation i have is that i require to connect the third party that is currently using the 'airbreak' solution using a secure iPsec VPN.I have bo...

At the moment we want to connect the ASA on two seperate internet connections . We create one LAN interface and two WAN interfaces. Now we want to create nat rules nat our outgoing traffic. After some research and testing (on a 8.0(4) asa) we have it...

Adriaan Mol by Community Member
  • 918 Views
  • 1 replies
  • 0 Helpful votes

Hi,I need to make a report of the VPN history on an ASA 5510 and I cannot find a way that fast.Please some info/tips.Thanks in advancegreetings,Pim van LutterveltSystem Administrator

helpdesk by Community Member
  • 1666 Views
  • 1 replies
  • 0 Helpful votes

Hi,On our ASA 5510 (running IOS 7.2) we have a global statement that does not have a corresponding nat statement e.i. global (outside) 2 x.x.x.x , but no nat (inside) 2 blah 255.255.0.0 I am assuming that this is a mistake and that global without a ...

marktaipp by Community Member
  • 1656 Views
  • 3 replies
  • 0 Helpful votes

Hi everybody ! i just deployed Cisco NAC version 4.8.1 Virtual Gateway OOB on a LAN envieronment and on a WLAN envieronment, it works fine for some users , they can authenticate via the agent or web page, and then they are redirected to the access vl...

Review Cisco Networking for a $25 gift card