Hello,
Although this message seems obvious, it doesn't make any sense. Can anyone shed some light? The router is a 2811 with an 8-port modem card. I'm troubleshooting because the modem answers and drops the call almost immediately.
Thanks.
VP
Does anyone know what's going on with this issue? The known fixed release 4.2(4042) is not available for download. I tested the two Hostscan releases that are available - 4.2.04018 and 4.3.00748 - and both are affected.
Regards,
Vincent
Is it possible to allow alwayson clients access to a specific host with a public IP whether the vpn connects or not? This is for allowing IT support remote access to clients for troubleshooting.Thanks for any ideas.VP
hello... Does anyone know if CSD/CAD 10.5 is compatible with UCCX 8.5?Situation is I need to upgrade CUCM from 8.6 to 10.5.But first must upgrade UCCX from 8.5 to 10.5 because UCCX 10.5 is compatible with CUCM 8.6 while CUCM 10.5 is not compatible wi...
Hello AJC,If you found the cause and solution, can you share? I'm seeing the same issue setting up a VWLC although everything on the switch port and WLC interface seem okay. Thanks.
Hello kyildirim.... Did you change timezone on the primary or secondary node? Documentation seems to suggest timezone can't be changed on the primary node.Thanks.
Hello everyone... as it turns out you don't need CUBE for SIP to SIP terminating on the same device. I was able to get this working without enabling the 4331 as a border element.
Thank you for all the responses.
Thank you Nipun. I found this document and am working through it.
https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications-manager-callmanager/117300-configure-cube-00.html
It doesn't have the provider side configs but...
What if I configure the 4331 as an MGCP gateway? Provider SIP to 4331, 4331 MGCP to CUCM. Is there any design I can use that does not require CUBE? The only aspect I cannot control is provider SIP.
Addendum... looks like MGCP endpoints can't be use...