About pompeychimes

pompeychimes · 04-01-2014

Anybody know how to determine the serial number of CSM 4.2.2 so I can purchase SMARTnet for it?

pompeychimes · 04-01-2014

I recently replaced a legacy 6513 with a 4510R+E running cat4500es8-universalk9.SPA.03.03.00.XO.151-1.XO.binUpon booting up a handful of workstations connected to the 4510 are unable to pull IP addresses. Once booted up, if you unplug and then plug t...

pompeychimes · 08-07-2012

15 years in and I'm touching my first IPS device. I've just plugged an ASA-SSM-20 into an ASA 5520. I'm looking for online documentation and there seems, at first glance, to be very little out there.I found this http://www.cisco.com/en/US/docs/securi...

pompeychimes · 07-30-2012

I can no longer communicate with the standby IP address configured on the inside interface of a secondary ASA5510. Just a couple days ago I could snmp, http, ssh, and ping it.From the switch that is directly connected to the inside interface I'm gett...

pompeychimes · 07-07-2010

I have a Linksys SRW224G4. Two PVE groups are in use. However I can't change which PVE group a port is assigned to. The option to change the group is there but ghosted out and can't be selected.I downloaded the user manual but it describes a web inte...

pompeychimes · 04-18-2020

I was really looking forward to this but i couldn't understand the guy. No disrespect intended. Cisco, please stop having non-native English speakers present English content. As a native English speaker i wouldn't dream of teaching something in anoth...

pompeychimes · 07-17-2018

On the L3 switch it sounds like you'll need a default route pointing to the 1841 router e.g. ip route 0.0.0.0 0.0.0.0 <IP of 1841 router> On the 1841 router you'll need a default route pointing to the D-Link router e.g. ip route 0.0.0.0 0.0.0.0 <IP...

pompeychimes · 04-29-2014

I'd forget about SDM and try to console into the router with a console cable and terminal emulator.

pompeychimes · 04-28-2014

Are you asking if you can use policy routing instead of /30's? If so the answer is no. Per my previous comment the traffic isn't even going to hit the router if all devices use a /24PVLAN is the right solution. Unfortunately you can't do this. Whatev...

pompeychimes · 04-28-2014

The problem is none of the traffic between devices on the same VLAN will traverse the router. Since they are on the same VLAN / IP Subnet all traffic will stay on the switch.The only thing i can think off now is to configure router on a stick with mu...

Member Since	‎05-06-2009 04:59 AM
Date Last Visited	‎07-14-2023 12:05 AM
Posts	302
Total Helpful Votes Received	83

User Statistics

User Activity

Cisco Security Manager (CSM)

Can't pull an IP address via DHCP

Where to start?

Can't communicate with the standby IP

SRW224G4 - Can't change port to PVE groupings

Re: Ask Me Anything- Basic Wireshark for Networking Students

Re: How to configure L3 to home router to access internet through cisco router

I'd forget about SDM and try

Are you asking if you can use

The problem is none of the