Network Security

This is my pix configurationglobal (outside) 1 interfaceglobal (inside) 1 interfacenat (inside) 1 access-list 100 0 0nat (inside) 1 10.0.1.7 255.255.255.255 0 0nat (inside) 1 10.0.1.8 255.255.255.255 0 0static (inside,outside) 203.129.203.165 10.0.1....

    Hi All,I have a Cisco ASA Firewall where it have three legs named as inside, dmz and outside with the security levels 100,50 & 0 respectively.i have the below configuration :nat (inside) 75 access-list outnatnat (inside) 25 access-list dmznatglob...

  HI I have two Cisco ASA 5540, these ASA running ver 7.2. and used mainly as VPN gateways.My question is simple, Apart from the extra AnyConnect client functionality and the higher encryption, is there any specific security benefits (related to the ...

Is it possivble to have 10 security licenses, license to a Cisco 5510 and have them transfeered to a Cisco5520?    

Hi,Is it possible to upgrade directly from 8.0(4) to 8.2(5) software in 5510. Is there be any workaround in regards to the config. Thanks,

Currently I have an asa 5510 set up with one block of outside IP addresses. Everything is working fine in regards to my initial setup. However we needed to purchase additional IPs from our provider and ended up being a whole complete different block....

I am going through http://www.cisco.com/en/US/docs/security/asa/asa83/upgrading/migrating.pdf and I have a question about nat exemption.  According to the guide above, the migration of nat exemption will look like this:-----access-list inside_nat0_ou...

Hi GuysI have the following in placeinternal network IP: 172.1.1.1 Natted to  DMZ IP of 192.1.1.1 I require thart the internal machine is able to access the internet however this is not happening and when checking the traffic logs I can see that it i...

Hi there,We have enabled inspection of RPC on TCP Port 135, to inspect the MS RPC response and dynamically open the ports.We have created a DCERPC Map with te following settings:Pinhole Timeout : 00:15:00Endpoint-mapper service:enforcedEndpoint-mappe...

Hi Expertsasa 5510 with 8.2 IOSwhy we put the same ip when we try to coonect from inside to dmz?ex:DMZ Server 50.50.50.50Inside: 10.10.10.10static (inside,dmz) 10.10.10.10 10.10.10.10why not static (inside,dmz) 50.50.50.50 10.10.10.10????????????????...

Can anyone please help me with this...I can access my webmail server from outside my network, but only if I type in the public IP address, eg https://webmail.mycompany.com does not work, but https://204.123.12.245/owa(not actual) does.  I am by no me...

Hi,started this on friday at about 5 pm am about at the point of throwing my hands up in the air from frustration.  I am trying to configure a dmz for a ip camera to be viewed from the outside. I had tried to set this config to NAT 10.1.35.5 to 2.2.2...