communication between 2 vlans.i have 2 vlansVlan 100 ip add 1.1.1.1!!!Vlan 200ip add 2.2.2.2i want to make communication between 2 vlans on firewall 5520 ASA 8.2.Please provide configuration for same.
communication between 2 vlans.i have 2 vlansVlan 100 ip add 1.1.1.1!!!Vlan 200ip add 2.2.2.2i want to make communication between 2 vlans on firewall 5520 ASA 8.2.Please provide configuration for same.
Hi all,I should upgrade ASA 5550 with nat controller enabled, from 7.2 to 8.x, I've been reading nat is differently configured up from release 8.3. So I choosed to upgrade to 8.2 release, can someone suggest me if there could be any incompatibility c...
folksi'm doing a bit of lab work and tinkering with gns and route distributioni'm trying to find the best way to filter routes (on an ASA) in the rip database so that only specific routes are distributed into a particular ospf process - at the minute...
Hello all,I am planning to integrate a Cisco 2621 (I know it's an older router) into our network alongside a Fortigate 60 firewall. The question I'm stumbling on is where to place the firewall - in front of the router or behind it? I figure that if I...
I have a Pix 515E running PixOS version 8.0.4 with two interfaces, inside and outside.On the inside interface, I have a Redhat Enterprise Linux 5.4 64 bits machine as an NFS server version 4 (NFSv4).On the outside interface, I have three (3) Redhat E...
I have the following class mapsclass-map data match access-list dataclass-map voice match access-list voiceand the following policy-mappolicy-map qos class voice priority class data police output 4500000 conform-action dropThe actual bps for "data"...
All,First thanks for any help given.I am trying to configure my ASA5505 to allow SMTP relay and the ACL\Static I created is not working.Here is the config:ASA Version 8.2(2)!names!interface Vlan1nameif insidesecurity-level 100ip address 192.168.1.2 2...
I have a setup where I have a secure internal network (192.168.1.0/24), a DMZ (192.168.5.0/24) and a public Internet connection. I have the internal network connection to the DMZ and the Internet safe, also I have my internet connection from dmz. But...
Current translations is an established stable network translation:static (inside,outside) 10.144.158.7 192.168.100.20access-list allows port 80While maintaining the above translation we have been ask by the developers to allow direct access to 192.16...
Trying to set up a asa 5505 in transparent firewall mode.I cannot set the management ip address:ciscoasa> enablePassword: ciscoasa# config termciscoasa(config)# firewall transparentciscoasa(config)# show firewallFirewall mode: Transparentciscoasa(con...
Hi All,There are two Polycom devices behind ASA (Terminal HDX7000 and MCU RMX1000), ASA is connected to Cisco 1900 router which is connected to ISP.Polycom devices are NATed (unique global address per device) on router and h323 inspection is done on ...
I have 2 Cisco Asa 5540 which works on failover infrastructure. I want to change some DOS attack configuration for TCP SYN attacks. Because my asa firewall crached when our partner started their penetration test . But I am not sure for these value ...
Hello all,Was wondering... The ASDM firewall dashboard... Anyone know of a way that we can export the view or otherwise dump it out into html?We have monitoring screens in the office with all our network status information, and the top usage stats ...
We care currently using an ASA5505 as our firewall and redirecting web traffic to a S160 Ironport. Recently the web fitler stopped working and the only way to get filtering again is to reset the redirection.My questions are:1. Is there any available ...
Hello,I am in the process of migrating a production firewall from PIX 6.3 to ASA 8.4(2). This is going to be a complete firewall rebuild and I will not be upgrading the configs because they have become out of date and very bloated. I am in the proces...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-26-2025 09:16 AM | ||
07-16-2025 04:21 AM | ||
07-06-2025 01:40 PM | ||
07-04-2025 01:59 AM | ||
06-19-2025 07:32 AM |
User | Count |
---|---|
8 | |
7 | |
7 | |
1 | |
1 |