We have Cisco 5525 with 9.14.4 with ASDM 7.18 currently working and we have purchased Cisco Firepower 2110 ASA appliance. I need to confirm whether for migration we only need to copy the running configuration from ASA 5525 and paste it into Firepower...
Forum Posts
Resolved! Monitoring traffic
Hello,I recently got a complain on the internet streaming through our internal network going out to Youtube or Facebook.In the normal hours, we are working fine, no one complain about the traffic or the streaming, smooth on everything.But during some...
Hi all,We recently acquired a CISCO 1010 FTD running version 7.2.4.1-43 to replace our current ASA 5505.The inside interface is configured as switchport trunk mode and associated with 5 different VLANs, everything is working fine, all devices connect...
Hi everyone I was on a old version with a issue that has been resolved, but i am currently stuck on version 6.0.0 with a file to upgrade to 6.1 Once i can get the file for 6.1 i can upgrade to 6.2 and keep on going upward. I was wondering if anyone...
How do I go about getting a copy of my cisco networking certificate from 2006
Hi, We have a requirement of configuring Multi factor authentication for the CLI login of FTD on ASA , Is there a way for achieving this .FTD version 6.2.3 running on ASA 5515 module .And the FTD is managed by FMC 6.3.0RegardsLingesha TS
Hello, One of our customer purchased FPR 1120 appliance with ASA image. But their current requirement is that they need to install FTD image in the FPR appliance instead of the ASA image. They don't need any next generation features like Malware, IPS...
Hi team,Have a client who wants to pull logs from the past calendar year from the firewall (MX84) - or as far back as it can go. The Meraki Dashboard only shows the last 30 logs. It would take a very long time to scroll back as far as the log retenti...
On my 5510, NAT rules appear to be needed for successful communication between interfaces at different security levels.On Ricky's 5540, the security levels alone are sufficient to control flow between these; no NAT rules are required.I'd say that was...
So i wrote a command like this)# enable password 123but when i type in 123 it still refuses access.i want to know what’s wrong with my switch why the password i assigned to it doesn’t work
Resolved! Upgrade FMC/FTD
We have a pair of 1150 firewalls running on a stand alone FMC. We're going to be upgrading the FMC first then the firewalls next. Looking at the upgrade path we can go directly from 7.0.4 to 7.2.4. Is that correct? I believe for the FMC we'll want to...
Hello All,Two - ASA 5525-X'sCurrent Version: 9.4(4)20Upgrade Version: 9.14.4I got the zero downtime upgrade steps from here: https://community.cisco.com/t5/network-security/asa-zero-downtime-upgrade/td-p/2154357One thing I'm nervous about is the IP A...
Hello, We are planning to deploy a pair of FTD appliances for one of our customer. We will be running routed mode and will use inline sets for the connectivity. The customer wants to configure SSL decryption for both inbound (for published services) ...
Hello Guys, Does anyone tried to make conditional NAT between different VRFs and is it even supported in IOS ?
In one or more of Cisco Press books, recall seeing the recommendation to not place any 4 tuple packet filtering rules in the main ACP but instead put them in the prefilter policy for performance improvements. In discussing with another FTD practition...
