Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I have several ASA 5540 firewalls in place and one of them iscausing me a lot of ulcer time.I am trying to pass Secure LDAP traffic through to an internal server.  Everything goes well until the server attempts to respond to the authentication on a d...

I know there are quite a few changes in the 8.3 release of the ASA software.  Is there a tool I can run my 8.2 config through that will output what the 8.3 config would be after the asa upgrades and converts itself?  I would really rather not bring m...

I have a new 5505 connected to a SF300 cisco switch and to my SBS 2008 internal server. My server and my PC are configured Statically and they were both able to access the internet without issue. When I tried to connect other PC's (same config, W7pro...

jima by Level 1
  • 1226 Views
  • 10 replies
  • 0 Helpful votes

v\:* {behavior:url(#default#VML);} o\:* {behavior:url(#default#VML);} w\:* {behavior:url(#default#VML);} .shape {behavior:url(#default#VML);} /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:...

Resolved! FTP?

hi,I want to know if I have FTP Server and I want to configure something on firewall or Routers so Client or user have only read-only access to FTP server or user can not upload or download the data from FTP server??

abhi-adte by Level 1
  • 1057 Views
  • 7 replies
  • 0 Helpful votes

hi1) if the AIP-SSM module is installed within the ASA firewall pair then for ASA failover to happen only the AIP-SSM hardware type needs to be same (i.e both should have say AIP-SSM-10) as mentioned in the below document or the software image also n...

jvardhan29 by Level 1
  • 6440 Views
  • 17 replies
  • 0 Helpful votes

i get following message when trying asdm(https://asa-ip) with ASA 5520 , 8.0 rel 4.asdm image disk0:/asdm-506.bin  The requested URL /admin/public/index.html was not found on this serverasa ip is 192.168.200.25. related configuration on asa is,http s...

suthomas1 by Level 6
  • 13954 Views
  • 5 replies
  • 0 Helpful votes

Hey all,I am in dire need of some help.  I am currently trying to open my NAT for use with Xbox live.  I have searched the forums and found great information but I cannot seem to get it to work for me.  If I do not use any port forwarding rules at al...

ckendzora by Level 1
  • 671 Views
  • 1 replies
  • 0 Helpful votes

Resolved! remote log viewing

I've been researching what my options are for capturing logs remotely. Any comments are appreciated.1. Syslog to a syslog server in cleartext over the internet is out for obvious security reasons.2. Site to Site vpn to a syslog server is possible, bu...

lcaruso by Level 6
  • 2066 Views
  • 6 replies
  • 0 Helpful votes

Hello,I am having problems with a FWSM with multiple contexts implementation.One of the contexts has a inside interface that must have a EXPLICIT deny ip any any.The problem is:When I put the ACE with the explicit deny at the end of the ACL all the t...

phmazzoni by Level 1
  • 1136 Views
  • 6 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card