Network Security

I have two routed ASA's that I want to run in active/standby mode.  But I'm short on IP addresses on the outside interface.  Is the standby ip address absolutely required for failover to function properly, or is that only used if that interface is mo...

Hello I would like to know the diffrence between:Trend Micro InterScan for Cisco CSC SSM 20 BASE and Trend Micro InterScan for Cisco CSC SSM 20 PLUS

     Does anyone have any configuration docs for an IPS module in an ASA 5520?Thanks,

Dear Team,Is there any tool available to check the most specfic acl for a particular IP/Network address.For Ex:1. Copy And Paste the acl from PIX/ASA to the tool2. Give IP and Subnet for queryIt should say which line will match for that IP/networkReg...

The short of my issue:I have configured a service policy that watches web traffic to a web server, limiting the maximum connections to the server (over TCP 80) to 'n' amount of simultaneous connections (set connection per-client-max n).  I need to se...

We have two asa5520 in active/standby failover setup . It happened so that primary got failed and the traffice is routed through secondary . When we saw the "show failover" the reason stated for failover says that " service card failure" and when we ...

hi,after i create zone-pair policy for outzone -> inzone, i facing that the problem that user in private zone cannot receive incoming mail from external mail server.   i use nslookup and check the ip for the external mail server - pop.singxxx.com, 16...

Hi there,I just discovered that my ASDM 6.3(1) is ignoring all my "service-object tcp [blabla]", "service-object udp [blabla]" and "service-object tcp-udp [blabla]" from my ASA 5520 v.8.2(2).That means that some service-groups show up as empty in the...

HiI have read in the document that the minimum required version for upgrading to 7.0(1)E3 is 5.1(6) or later.Does that implies that one need not go for upgradation from 5.1(6) to 6.X and can directly reach 7.0(1)E3 ?Also , I have a query regarding pa...