Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Can anyone point to a Cisco document that cleary describes source and destination NAT, the differences between them, why you would use ource over destination & vice versa and any configuration examples on an ASA.ThanksPaul

paultribe by Level 1
  • 827 Views
  • 1 replies
  • 0 Helpful votes

I have a Cisco 1841 router.I need to open PPTP (1723) and RDC (3389) so that I can access my servers from the outside.  I tried adding some NAT and ACL rules but it did not work.  This router is also connected to another office with a VPN which I thi...

cisco by Level 1
  • 1672 Views
  • 4 replies
  • 0 Helpful votes

I have an issue but I dont think its the asa 5520 or IPS thats causing it. A programmer is trying to use the listed items in the HTML code;Cache-Control  no-cache    Pragma    no-cacheIs there as place in the asa 5520 or IPS that would interfear with...

We have an ASA5510s which has a VPN to a remote client with networks of 192.168.61.0/24 and 192.168.62.0/24 (note that these are the actual network IP ranges and not used here to substitute for public IPs).  One of our internal networks is 10.2.1.0/2...

pootboy69 by Level 1
  • 1334 Views
  • 8 replies
  • 0 Helpful votes

Hi,I have to disable the commands below:policy-map type inspect h323 NO parameterspolicy-map type inspect h323 NORAS parameterspolicy-map global_policy class inspection_default  inspect h323 ras NORAS Was told by a consultant to type no before inspec...

mojorizn1 by Level 1
  • 3765 Views
  • 2 replies
  • 0 Helpful votes

Hello,I've been working on an asa 5505 config at my office.  Getting ready to test at our client site soon and would like to post the sh run output for the experts to review as I'm new to Cisco products.  The objectives of this firewall are:1. Allow ...

andyhoien by Level 1
  • 1414 Views
  • 5 replies
  • 0 Helpful votes

I am trying to find out if anyone has had luck with setting up a DMZ on a ASA 5505 with a basic license. I belive it should be possible to do but have not been able to get an outside connection to work when connecting it through a linksys router acti...

it by Level 1
  • 2269 Views
  • 4 replies
  • 0 Helpful votes

Hi,I'm a new user for ASA, anyway by reading cisco document I have done some basic configuration. At this moment my requirement as follows:-1. Access to DMZ server( 191.20.20.0/24) ( ping & Other service like http etc ) from Inside User VLAN ( 172.16...

sdasgupta by Level 1
  • 22255 Views
  • 8 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card