Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi all...I have a questiong regarding how ASA handles udp flow...I have 2 applications that are communicating via udp. These 2 applications are between 2 ASA firewalls. These 2 ASA's are connected with DLL link as a primary line and VPN IPSec over th...

nikolag21 by • Frequent Visitor
  • 2439 Views
  • 8 replies
  • 0 Helpful votes

Resolved! asa vlan

is there is a way to create vlans on asa 5520. i am looking at assigning two asa ports on a single vlan.Please help with suggestions.Thanks in advance.

suthomas1 by • Level 7
  • 2894 Views
  • 9 replies
  • 0 Helpful votes

We currently have a Juniper 5gt with the internal ip of 172.16.1.254.  We are replacing it with an asa.We have a couple of dumb switches and an MPLS router with an IP of 172.16.1.253.  Right now everything is fine.  The internet traffic goes through ...

jwashburn by • Community Member
  • 1000 Views
  • 1 replies
  • 0 Helpful votes

Hello all,I have a case open with the TAC already on this, but I thought I would throw this on the community forums (this is my first post) since there might be others experiencing a similar issue.I've come to expect being able to translate the sourc...

mnantel by • Community Member
  • 4051 Views
  • 4 replies
  • 0 Helpful votes

Recently some of our users complained not reaching some sites. So I did some steps to isolate the problem.1. ISP port -> Single workstation (I was able to reach any site without any problem).2. ISP port -> Router -> Single workstation ( Like the firs...

slasher UG by • Community Member
  • 1650 Views
  • 6 replies
  • 0 Helpful votes

Hi guys,I am working on deploying an ASA 5520 with 8.3.  The issue I am having is pretty simple.  What is the best way for me to allow traffic to communicate between my Inside network and my DMZ in regards to NAT.Please keep in mind that 8.3 changes ...

Hello!I am supporting a customer who has an ASA 5510 (8.04) connected to two ISPs. He wants to use one ISP for internet access, and the other ISP to publish several servers from the DMZ with NAT. So, basically splitting the traffic, all internet acce...

giamwi by • Community Member
  • 1534 Views
  • 3 replies
  • 0 Helpful votes

1st qeustioni am trying to pass my wireless users through nac. i have catalyst 3560 switch to which everything is connected to including the nas,nam,wlc and ap.the problem is i can see the wireless users registered in the nam but they are unable to p...

mshebelle by • Community Member
  • 1861 Views
  • 4 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card