I was considering buying a used ASA from someone a little while back. the Sh ver showed 100 SSL licenses!(was running 8.04). The person told me that he later updated it to 8.3 and it dropped to 25. Anyone seen/have an explination for this?
I was considering buying a used ASA from someone a little while back. the Sh ver showed 100 SSL licenses!(was running 8.04). The person told me that he later updated it to 8.3 and it dropped to 25. Anyone seen/have an explination for this?
/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Tabel - Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margi...
Hello,Just wonder why I cannot access ASDM from management interface of Cisco ASA 5520 considering that there is preconfigured ip address in the management interface 0/0 (factory default). When I type https://192.168.1.1 (management 0/0) ASDM site an...
Hi,Does anyone know how the inside host limit could change from 50 to 10?We've had the unit for a while now and it had been fine. However recently users have started complaining of being unable to access the internet. When we checked the ASA it is sh...
Hi all,We are running a PIX 515e with Cisco PIX Security Appliance Software Version 8.0(4). When running TFTP session through the firewall the firewall doesn't recognise the return traffic as part of the TFTP connection. I understand how the TFTP ...
Hi folks,Can someone advise on the names or signatures that could be successfully used to monitor the usage of streaming applications on the network. The plan is to feed them to MARS and then create reports on streaming applications utilization to us...
I had ASDM working on the management interface and then I changed the IP address. When I did that I can not get into anymore. I have "http server enable" and "http x.x.x.x x.x.x.x management". I can ping the interface so I know I can get to it. ...
I want to share an observation with sig498. We deployed to several 4215's and the update would hang our sensors. We deployed via CSM. In order to recover we had to utilize the service account, log into each sensor and reboot from the bash prompt. Aft...
I need some product advice the ASA 5510 which we are looking at to replace checkpoint Nokia IP260 clustered using VRRP1) Does the ASA support auatomatic fail over if one of nodes in a cluster fails ?2) We currently have ISP redundancy with checkpoint...
Hello!We plan to use WCCP with a Cisco ASA 5510. How can increase the CPU load of Cisco ASA 5510 with HTTP traffic about 100Mbps?Current CPU load about 30-40%.
i have csm 3.2.2 , and added cisco router to the csm , and discovered policied , when i want to daploy any configuration , during validation i get the above error , that need to be fixed in order to continue the deployment
hi all: we got one ips 4270 sensor.one of the cpu always overload(over 95% in the IME soft),but when i use the command "show statistics virtual-sensor | in processing load percentage" to check the cpu usage rate.it's under 5. sometimes the s...
I'm trying to figure out if active timeout is supported on ASA 8.3 Netflow export? The example below is from a Cisco IOS 4K switch. 1. Following Netflow V9 fields must be exported: IPV4_SRC_ADDR, IPV4_DST_ADDR, IN_BYTES, IN_PKTS, L4_SRC_PORT, L4_DST...
I have several Cisco 877 routers that I manage from the Internet as they are at customer sites, I have just installed a Cisco 1841 and I am trying to setup the same management.Both the 877 and the 1841 are using the Advanced Security IOS. The proble...
Hi, I am after a general consensus on permit ip any any, is this command ever acceptable ?A PCI audit has just taken place on our network and a permit ip any any was found, since then all hell has broken lose. Please see below explanation for the de...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 09-22-2026 04:13 PM | ||
| 08-25-2026 06:22 PM | ||
| 08-24-2026 12:26 AM | ||
| 08-20-2026 05:54 AM | ||
| 08-19-2026 07:59 AM |
| User | Count |
|---|---|
| 4 | |
| 2 | |
| 1 | |
| 1 | |
| 1 |