Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I am working on a project in which i have to remove a PIX 515E and have to connect an ASA 5510, i have copied all the commands from PIX to ASA except the conduit commandsfollowing are the examples of the conduit commands i haveconduit permit tcp obje...

Greetings.I have a problem. We're planning to add an ASA into our network for VPN and firewall purposes. I've hooked the ASA up to the network and so things look a bit like this:-Bridged Internet Connection --->> ASA 5510 --->> 1841 Router --->> Netw...

Hi.. We are having FWSM between aAvaya voip phone and call manager server. We are using NAT and access lists for allowing the traffic. Our calls rings both ways but not able to hear the voice. Our observation is as below :When the IP telephony handse...

Our company recently purchased 2 ASA 5510 's to replace our current Sonicwall.  Well after some research it looks like I will have to run them in transparent mode because of the way our network is configured.  I have the ASA set up in transparent mod...

rgiammanco by Community Member
  • 1843 Views
  • 8 replies
  • 0 Helpful votes

Dear All,I need to be able to allow access from a host in my internal network, 192.168.116.33 to gmail.com on TCP port 533.The traffic is actually http but different port is used.Is it possible to do this using MPF?All other traffic should remain una...

ahassiotis1 by Community Member
  • 2409 Views
  • 5 replies
  • 0 Helpful votes

Newbi question....What is the different for these two nat commands (asa v8.3)nat (inside,outside) source static 10.10.10.5 88.234.23.2object network obj-10.10.10.5 nat (inside,outside) static 88.234.23.2The first is a NAT rule and the second is a net...

I am trying to run syslog reports in LMS.  When I run the 24 hour syslog report nothing is found.  No data on the report.  I am trying to troubleshoot this.  How can I  tell if my traps are getting to the Ciscoworks server (10.223.241.32)?  Is there ...

dtom by Level 6
  • 1434 Views
  • 1 replies
  • 0 Helpful votes

Hi,We bought a brand new ASA 5550 with a 4GE SSM Module.The problem is that whenever i connect to the SSM Module, it is physically up, but it cannot detect the PC that is connected to it. The isolation I've done is to try the same configuration done ...

ninoy_lim by Community Member
  • 1716 Views
  • 1 replies
  • 0 Helpful votes