Network Security

Hiwe are having ASA firewall on which 3 (ISP) links are terminated.(There is no router in between)If end user wants to choose perticular ISP for internet access . How can route traffic to perticular interfaceIs PBR is possible on ASA?or is there is a...

I am configuring a Cisco ASA 5505 I still have access to the firewall through my pre installed ASDM, but if I try and web broswe I get page cannot be displayed and the following entry in my firewall6Sep 06 201013:57:5210.0.1.775304810.0.1.90443Teardo...

Hi There,I'm still finding my way around Cisco firewalls at the moment, and could use a little help regarding tracking clients usage.What I'm after is a list of internal IP addresses, and the total download / upload stats from them.I had a look at th...

Hi all,I recently upgraded a router to asa5505. I did a static NAT for a particular private ip address to public ip as below.static (inside,outside) public_ip private_ip netmask 255.255.255.255However when this is done, this particular server could n...

Hi all,attached is the design for a back to back two ASA 5510 with AIP-SSM and CSC-SSM. KIndly advice me on this design, configuration and the security levels that will be attached to each interfaces.Thanks In Anticipation!Tunde

Does an update of the PDM (actually 3.0.4) for pix version 6.xxx is planned to resolve the problems of compatibility with the jre sun?Thank you

Dear all,I have failed to upgrade the software of my AIP-SSM-20 on the ASA. The AIP-SSM-20 had an Image of version IPS-K9-5.1-7-E1.pkg and I tried to upgrade it to IPS-K9-6.1-1-E2.pkg but after the upgrade the AIP-SSM-20 became unusable. I can no lon...

Is it possible to configure the ASA to forward a packet with a destintion port of 80 to a destination port of 8080, without translating the original destination IP address?

Hi Community,I've prepared a scenario for test environment to clear some doubts, please see the attached image.You can I have 3 interface on ASA and web server with a public ip address.My question is that1. When someone will try to access this webser...

Hi all,My HQ office has site to site vpn established with all our subsidiaries.Is it possible for the subsidiaries to communicate with each other using the site to site vpn link to HQ without creating another site to site vpn link between subsidiarie...

Hi,Static and NAT - configuration for : ASA Version 7.2(4)33.static (outside,inside) 10.100.0.0   10.100.0.0    netmask 255.255.0.0Packets generated from inside zone, whose source IP - is- any  and have destination IP in the range of 10.100.0.0 /16, ...

We have just recently installed a Cisco ASA 5510 firewall and have got the configuration all up and running, however due to current project we are running, we have allocated a single public ip address for a third party company to tunnel in on that ad...