Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello All,I can't seem to get ASA authentication request, or config changes alerts to be forwarded to our syslog server.  I'm able to see all normal ASA messages, blocked messages, VPN authenications, etc, but if I fail a login, or make config change...

smjaggers by Community Member
  • 7368 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Pix Capture

Hi Guys,Have a question on Pix Capture. Does the pix capture also capture the packets which are being dropped by the firewall? Normally we see the drop packets in the logs so wondering if i put capture on the firewall, will the pix capture capture th...

Hi,I dont have any experience with the Cisco IPS product.I can not open a web site because of the IPS. When I shut down the IPS module the web site can be accessed.Can you guys tell me how to allow access to  a particular web site?

We know that exist a PICA accounts in our clients to get the signature dynamic updates, but cisco won't use this type of account anymore.So the question Is:What type of account do i have to configure to obtain the signature dynamic update for my clie...

amunoz by Community Member
  • 741 Views
  • 1 replies
  • 0 Helpful votes

I have ASA with two DMZ interfaces. I have requirement to route trafic from one device in first DMZ zone to a Public NATed IP of the device in second DMZ zone. Example: first DMZ 10.10.10.0/24, second DMZ 10.10.11.0/24Device in first DMZ has ip 10.10...

nataliakram by Community Member
  • 610 Views
  • 1 replies
  • 0 Helpful votes

I have a customer that has the botnet filter installed, they were having issues sending email to one of their partners, because the botnet filter was classifying this site as very high Malware.  I check senderbase and there reputation is good.  How d...

Hello, I am having some issues with adding a policy-nat for a L2L vpn in order to nat all the private address sent across the tunnel to single address (9.43.121.7).When i try to add the statement:static (inside,outside) 9.43.131.7 access-list vpn-pol...

jventura by Community Member
  • 1543 Views
  • 2 replies
  • 0 Helpful votes

Hi,Having just upgraded my PIXs to software v8 at last I was hoping to have them partake in OSPF on the network.The PIXs all have lots of DMZs which I would like to advertise over OSPF to remove a *lot* of brittle static routes but of course I would ...

PeterWorth by Community Member
  • 3450 Views
  • 5 replies
  • 0 Helpful votes