I acquired this unit and I am having issues with it, I did the recovery and I set the new password and it is keep going back to it, how do I get out of it?CISCO SYSTEMS IDS-4215Embedded BIOS Version 5.1.7 03/02/04 11:20:35.01Compiled by dnshepEvaluat...
Has anyone out there had issues using Identity NAT and Windows Server 2008? We have a client that recently upgraded their Windows 2k3 server to 2008, and started getting "Duplicate IP" messages on their 2008 boxes. Through some testing we were als...
Hi allIs there any reason why I wouldnt be able to telnet to my standby asa? I can ping it from the other ASA fine,via the lan interface, but I cannot ping it from other subnets, should I be able to get to both firewalls for management in the active/...
Hello,im using cisco works on a windows server system every 3 or 4 Weeks my backup fails because of "no disk space".Searching for the reason i found that DFM.log is too big. After removing this file the backup runs propperly.Removing this file nee...
I am looking for configuration examples on setting up VLAN-based virtual interfaces with a PIX 506e and a 2950 switch.I need a DMZ on this PIX, and noticed this option. HAs anyone set this up before?
Hi,This is a case in which i seek ur help here,i have to deny internet access to a group of ten hosts but allow them access to particular domain e.g.;xx.in ,could any one help how to udo this using Access lists on router gi 0/0 interface.
Is it normal for traffic between hosts on the same subnetto be "Proxied" by the ASA interface ? If I turn off proxy arp it breaks the configured NAT.thanksKeith
Hi Folks,I get sevral alerts from my IDS system says, "Windows System32 Directory File Creation" as an event.Could you please help me out understand the exact meaning for this alerts.Thanks in advance,Sameer
HiMy site to site ipsec tunnel is not coming upR2>R0>FW>R3connectivity is ok.Plz find the configuration od R2 and FirewallR2============================================================crypto isakmp policy 10 hash md5 authentication pre-share group 5e...
Hi All,I need your expert advice on the following:In CISCO ASA 5510; I need to do a NAT for two internal IP's to one External IP in CISCO ASA. Please help me on this. I have one global entry for one internal ip which required to be included in above...
Hello,I am new to firewalling with Cisco devices and need a point in the right direction to create a failover cluster between two C2851 (12.24T) configured as a IOS Firewall. Any information, how to's or links would be appreciated.ThanksMichael
Hello,I am very basic knowledge of ASA5505 and I recently purchase one for home usage.I need assistance in hardening this ASA.Below is my current config, please advise suggestions to lock it down.Also, I am having trouble entering for the following c...
Dear Experts, I request your assistance. I am trying to test the SSL VPN (WEB VPN in Cisco ASA). It is working perfectly by default configuration. Now I am using OUTSIDE INTERFACE as SSL VPN Terminating point as below web vpn enable outside Is it p...
Hello all,I currently took over a System Administrator position and now have the job of configuring an ASA5510. However, i am not CCNA/P certified and have never had the "joy" of configuring one. I need to open up port 1723 to allow external access t...
Any help is appreciated.(1) Equipment: PIX515(2) Connection scenario:Far side WAN 10.1.2.61, PIX outside: 10.1.2.62. However, all incoming IPs from the other end are: 10.100.100.x/24(3) Need to map incoming 10.100.100.x to internal 172.30.1.x,. For e...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 06-03-2026 12:48 AM | ||
| 05-26-2026 07:54 AM | ||
| 05-02-2026 06:09 AM | ||
| 04-30-2026 12:46 AM | ||
| 04-24-2026 07:04 AM |
