Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

HiI am trying to set up a Site to Site VPN tunnel between Site A and Site B.I ran through the VPN wizard on both sides but the tunnel isnt active.Site B already has one VPN to an IP of 62.77.xx.xx and I need to change this to a new IP.I will attach b...

I have two desktops in one  department on one side of an ASA 5505 natted thru to addresses on the other side of the firewallThe ACLs allows ICMP in both directions.  I can remote desktop to one desktop and not the other.  I can ping the same desktopa...

tbasile by Community Member
  • 1004 Views
  • 6 replies
  • 0 Helpful votes

I use a Cisco ASA 5520 with version 8.2(2)What I want to do ist to log some of the ACEs configured.How it works:# logging enable# logging trap informational# logging host inside x.x.x.x# access-list inside_access_in extended permit ip any any log =>...

ASA 5510 7.21 -- it's driving me crazy!  The device itself can ping and be pinged, so internet connectivity is good.  The packet trace function says the inbound traffic *should* be permitted "RESULT - The packet is allowed." for any number of protoco...

vemlyon by Community Member
  • 2506 Views
  • 3 replies
  • 0 Helpful votes

Hello, I hope someone could help me out. I'm trying to figure out how the new NAT is working in 8.3. Problem:I have an ASA behind an DSL connection with exact one dynamic external IP (e.g. home office). In my internal network I have two servers one F...

m.hoeschen by Community Member
  • 2277 Views
  • 3 replies
  • 0 Helpful votes

Hi,  Can anyone tell me if this is ok? i see this two ports that are connecting to my exchange and AD. UDP outside1 192.168.1.106:6004 inside EXCH01:31970, idle 0:00:42, bytes 8, flags -UDP outside1 192.168.1.106:6004 inside EXCH01:31959, idle 0:00:4...

Mon Baul by Level 3
  • 6646 Views
  • 8 replies
  • 0 Helpful votes

Hi,I have a problem when go to insert a Nac Server in our Nac Manager the message that appear is "Failed to add server: Maximum limit for Clean Access Servers supported has been reached " but I don´t have any Server yet in this Nac Manager.Anybody ha...

wsilveira by Community Member
  • 1070 Views
  • 2 replies
  • 0 Helpful votes

hi,  could anyone confirm if doing the NAT in the router is better that doing it in a firewall?because someone told me this is the best practice from cisco. My topology below: CoreSwitch==>edge switch-->ASA-->Boarder router Note: i have server in dmz...

Mon Baul by Level 3
  • 5547 Views
  • 5 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card