Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello,On an ASA5510 v8.0(4) is there a way to create a network object group and enter a range of addresses rather than entering them one at a time? For instance I have a group that will need IP address 192.168.1.60 to 192.168.1.75. Do I have to ent...

mfruvous by Level 1
  • 699 Views
  • 2 replies
  • 0 Helpful votes

NAT

Hi,I have ACL_INSIDE to restrict all traffic from inside to outside.I want to allow VPN Traffic from inside to outside.Do I need to have NAT statement for all LAN IP. Example:-NAT(inside) 1 192.168.1.0 255.255.255.0

Hi Guys,Can anyone tell me what happens to the respective traffic if I have the following configuration?I am a little confused between the action forward/drop and permit/deny meanings?vlan access-map TEST 10 match ip address TEST-ACL action forward!v...

I have an ASA5505 with 8.2.1 firmware version and 6.2.1 ASDM version. I cannot access the firewall using HTTPS (ASDM). When I try to access it from IE, the message "The page cannot be displayed" is returned. When I try to acccess it from Mozilla, the...

Resolved! NAC Questions

We have 2 CAS should be configured with HA are located in the WAN Zone of the FWSM. there is a static NAT meansstatic (inside,WAN) 10.0.0.1 10.0.0.1 netmask 255.255.255.255where 10.0.0.1 is the ip of CAM and the cas has 20.0.0.1.I have read that if t...

talha_490 by Level 1
  • 1162 Views
  • 4 replies
  • 0 Helpful votes

I have a pair of ASA 5510 with security plus license. I am going to setup site-2-site VPN on them in Active/Stanby configuration STATEFUL failover. I WILL NOT BE USING ANY 802.1Q. I will be running ASA 8.2.1 code.The ASA5510 comes with 5 interface...

cisco24x7 by Level 6
  • 5749 Views
  • 15 replies
  • 0 Helpful votes

Hi! expertsI using AIP-SSM-10 module on ASA 5540But it is not working auto update signature.So I `m going to attach " show statistics host" result.Can you tell me some help?Thanks in advanceAuto Update Statistics lastDirectoryReadAttempt = 07:34:50...