Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I am trying to set up a traffic shaping policy for outbound traffic on a Pix 515 to restict total outbound BW to 1 mbps. Below is the config I have set up. What is happening that uploading to external sites is indeed restricted to 1 mbps but uploadin...

ricey by • Level 2
  • 871 Views
  • 1 replies
  • 0 Helpful votes

Hi AllI have a query regarDing the Cisco IDSM , ASA -AIP-SSM (IPS) and IPS 4200 series sensors' hardware bypass unit . Please let me know if the hardware fails in both the cases how will the traffic pass through .Is there any inbuilt hardware bypass ...

I am installing a ASA 5510 in transparent mode, it's behind a cisco 3745 router that has NAT translation in the configs.After I set up the ASA 5510, I created access lists for web server access. All traffic inside passes thru fine however, when an ou...

opsmaster by • Level 1
  • 8679 Views
  • 38 replies
  • 0 Helpful votes

HelloI Have Connected the RS Straight Through cable with 2 DB 9 Female to both end PC/Console and VPN Concentrator 3005 with the following settings as described in cisco document ….I've attached image for cables that I use• Bits per sec: 9600 •...

alsayed by • Level 7
  • 1226 Views
  • 4 replies
  • 0 Helpful votes

I was hoping to allow my local LAN (192.168.60.x) the ability to access the internet through my ASA 5505 while still maintaining the VPN tunnel that is required. I just recently added a number of access-lists to my config, which resulted in internet ...

cavemanbobby by • Community Member
  • 2283 Views
  • 7 replies
  • 0 Helpful votes

Hi all,I am new with NAC and I am planning to upgrade NAC appliance 3140-H1-FB, a HA pair, to version 4.5.1. If anyone out there already done so please give me your point of view of the upgrade and if there is any problem that I should avoid during t...

ttran by • Level 2
  • 1020 Views
  • 4 replies
  • 0 Helpful votes

Has Cisco quit supporting the 5xx series PIX software?I wanted to download 8.0 code for a 515e, but all of the PIX 5xx options do not provide image for download. Is that it for 5xx software support?thanks, Kevin

ksvy_ksvy by • Level 3
  • 1532 Views
  • 3 replies
  • 0 Helpful votes

I have used SDM to setup a firewall on my 871w router. The firewall is set to allow GRE and pptp on both in to out and out to in. But I am still unable to establish a VPN connection to the server. I know the server is working properly because there a...

derrick by • Level 1
  • 755 Views
  • 2 replies
  • 0 Helpful votes

Hello.I am looking for examples of the NAC Appliance with load balancing. Either with CSS boxes or an ACE module. For example, can you do load balancing in L2 virtual gateway mode? Are there examples anywhere? I cannot find any.Thanks if anyone can h...

brobinson by • Level 3
  • 779 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card