Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have deployed a C9800-CL on VMware, inside ESX I can see three interfaces.. But on the Controller there is only two. Does anyone have any idea what has happened to the missing interface? RegardsIan
Hi all, I have a WLC 5508 controller running 8.5.140.0 and I am trying to move the access points off this controller to a 9800-l running ios-xe 16.12.3 When I move an AP from the 5508 to the 9800 it will not join.I have checked the other posts with s...
Hi Has anyone used 3rd party optics in a Catalyst 9300 Series Switches, running Cisco IOS XE Everest?
Does the "service unsupported-transceiver" still work in this platform and software?
Many thanks
Ian
Hi All,
I am noticing some unusual behaviour with multicast and IGMP.
The Mcast topology is as follows
Router01 ------Core_Router------ Primary_RP_Router(10.129.0.9.1)
The config on router01 is
!ip pim bidir-enableip pim rp-address 10.129.0.9 1 ...
Hi all,
I am configuring a Nexus 5600 as a leaf node for VXLAN and I cannot enter the following command
"fabric forwarding anycast-gateway-mac"
This appears to be missing in the feature set.
Everything else is fine it is only this command that i...
since it is in a remote location I have done a factory reset via the CLII haven't tried it with the mode button. In the packet captures taken it discovers the WLC authenticates sends the join message, and receives an encrypted alert back from the WL...
The Access points are 2800.I have used a brand new unit and it connected successfully to the 9800 controllerI failed this to the 5800, and the AP associated fine.I then went to reassociate the same ap back to the 9800 but will not join. I have check ...
Yes I have.
I found I needed to install the following feature set.
install feature-set virtualizationinstall feature-set fabricfeature fabric forwarding
Working config of a leaf is shown below.
!Command: show running-config!Time: Wed Jan 31 22:11:...
