Network Security

Hi,I want to enable antispoofing on PIX firewall by using command ip verify reverse-path.My understanding is I need to define a default route on the PIX before I can use this command. Is that true?Regards,Eric

dear all,i would like to have a support to allow traffic of PPTP and GRE ports

Hello all,I'm pretty decent in the world of Cisco but I'm having trouble getting traffic to flow out with a ASA 5505 on Verizon DSL. I have a static IP with Verizon and I'm using their Westfall 7500 modem/router as a routed bridge into my network.The...

Hi,Does it possible to configure IPS to send shun request to a FWSM module?On IME there are only three device type to configure shun request1 PIX /ASA2. Cat6K3. Cisco RouterRegardsDileep

I've got an 1811 series router (and I have a 1700 series with same config with same issue).We have a crypto tunnel between two locations. A <=======> WAN <=======> BLocation A has one subnet. 192.168.77.1Location B has two. 10.10.1.1 and and external...

I have Windows 7, 64-bit Enterprise running and need a solution to VPN in to my home pix 501 and some customers PIX 506. They are running the 6.3.5 code.I could make a VM but would like to have a solution for my primary OS.

Referring to the attached diagram.(sorry if the diagram is not too neat, had to sketch in a hurry).There are 2 different internet lines being used at different sites.All internet traffic from Layer3switch 2 uses that internet link. & internet 1 is us...

This could be related to a previous conversation of mine: http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Security&topic=Firewalling&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.2cd34318This has now come up:Host A ...

Hi All.I have this problem. I manage a remote datacenter network from an ASA outside interface.The same host must be accessed from outside by customers by its natted IP address (200.x.x.1) and, at same time, by staff by its real ip (10.x.x.1) “ANDâ...

We have migrated the supervisor card from III to SUP 720 on Cisco 6509.I get this error from Inventory Collection :RICS0001: Internal Error,unable to process the collected data from the device.Normally, this change should be detected and the inventor...

Hello,I have and ASA 5510 and would like to be able to access the MGMT network including the AIP-SSM module from the internal network. I am a Cisco newbie.Mgmt port: 192.168.22.1AIP SSM Mgmt port: 192.168.22.254Internal network: 192.168.1.0/24I can c...

We have a Windows 2003 server running IIS and a custom built ASP.net application on it. Before we switched to an ASA5520 we had a Watchguard Firebox appliance in front of it and all was good. After the switch to the ASA we started getting reports of ...